On 5/29/08, Tim Evans <[EMAIL PROTECTED]> wrote: > > I'm attempting to move a previously working Maxtronic SA-3340S > SCSI-to-SATA disk array from a Sun Sparc system to a RedHat 5.2 system > running on Dell 2950 hardware. > > While I don't expect, of course, to get at the data on the array, I would > like to deploy it. > > The Dell sees the array, and /var/log/messages reports: > > May 29 08:40:35 s31e066 kernel: SCSI device sdb: 2925232128 512-byte hdwr > sectors (1497719 MB > > May 29 08:40:35 s31e066 kernel: sdb: Write Protect is off > > May 29 08:40:35 s31e066 kernel: SCSI device sdb: drive cache: write back > > May 29 08:40:35 s31e066 kernel: SCSI device sdb: 2925232128 512-byte hdwr > sectors (1497719 MB) > > May 29 08:40:35 s31e066 kernel: sdb: Write Protect is off > > May 29 08:40:35 s31e066 kernel: SCSI device sdb: drive cache: write back > > May 29 08:40:35 s31e066 kernel: sdb: sdb1 sdb9 > > May 29 08:40:35 s31e066 kernel: sd 2:0:0:0: Attached scsi disk sdb > > Despite the indication scsi disk sdb was "attached," and the presence of > sdb device files in /dev, the system reports: > > # fdisk /dev/sdb > > Unable to open /dev/sdb > > There are extensive, repeated dmesg entries, however: > > scsi2 : Adaptec AIC79XX PCI-X SCSI HBA DRIVER, Rev 3.0 > <Adaptec 39320A Ultra320 SCSI adapter> > aic7902: Ultra320 Wide Channel A, SCSI Id=7, PCI-X 101-133Mhz, 512 > SCBs > > Vendor: Model: Rev: R0.0 > Type: Direct-Access ANSI SCSI revision: 04 > target2:0:0: asynchronous > scsi2:A:0:0: Tagged Queuing enabled. Depth 4 > target2:0:0: Beginning Domain Validation > target2:0:0: wide asynchronous > target2:0:0: FAST-160 WIDE SCSI 320.0 MB/s DT IU QAS RTI WRFLOW PCOMP > (6.25 ns, > offset 127) > scsi 2:0:0:0: Attempting to queue an ABORT message:CDB: 0x12 0x0 0x0 0x0 > 0x40 0x0 > scsi2: At time of recovery, card was not paused > >>>>>>>>>>>>>>>>>> Dump Card State Begins <<<<<<<<<<<<<<<<< > scsi2: Dumping Card State at program address 0x24 Mode 0x22 > Card was paused > [ lengthy hex messages elided ] > <<<<<<<<<<<<<<<<< Dump Card State Ends >>>>>>>>>>>>>>>>>> > scsi2:0:0:0: Cmd aborted from QINFIFO > scsi 2:0:0:0: Attempting to queue an ABORT message:CDB: 0x0 0x0 0x0 0x0 > 0x0 0x0 > --
Would you be able to re-initialize the array?
_______________________________________________ rhelv5-list mailing list [email protected] https://www.redhat.com/mailman/listinfo/rhelv5-list
