Cloning the riak repo and building worked fine. However, not being able to build from the tarball is a little disconcerting... --Matthew
On Fri, Apr 23, 2010 at 12:13, Matthew Pflueger <[email protected]> wrote: > Thanks for the tip. Unfortunately, disabling doesn't seem to work... > I disabled it in my ~/.hgrc and in ebloom's .hg/hgrc to no avail. I > downloaded riak-0.10.tar.gz and installed so no .hg directory. Any > other suggestions? > > --Matthew > > > > On Fri, Apr 23, 2010 at 11:56, Ryan Tilder <[email protected]> wrote: >> Sounds like you have Mercurial's inotify extension enabled. hg showconfig >> should show it. Workaround for now would be to following the directions in >> the below link for disabling the extension in the riak repo. In >> riak/.hg/hgrc: >> [extensions] >> inotify = ! >> http://mercurial.selenic.com/wiki/UsingExtensions#Enabling_an_extension >> >> --Ryan >> >> On Fri, Apr 23, 2010 at 8:48 AM, Matthew Pflueger >> <[email protected]> wrote: >>> >>> I downloaded built Erlang successfully (minus jinterface, odbc, and >>> wx) then downloaded riak-0.10. I did a make all and everything built >>> fine but then doing a make rel I get the following: >>> >>> ==> rel (generate) >>> ERROR: Unable to generate spec: read file info >>> /home/mpflueger/riak/rel/../deps/ebloom/.hg/inotify.sock failed >>> >>> Has anybody else run into this? Could this be related to my mercurial >>> install (I'm using 1.51 downloaded and installed normally using >>> python2.5). >>> >>> --Matthew >>> >>> _______________________________________________ >>> riak-users mailing list >>> [email protected] >>> http://lists.basho.com/mailman/listinfo/riak-users_lists.basho.com >> >> > _______________________________________________ riak-users mailing list [email protected] http://lists.basho.com/mailman/listinfo/riak-users_lists.basho.com
