I have 3 GPIO devices. QOR32 set with layer D. This is where I have the hard wired GPIO connected. ASI 6585 layer V and a GPIO xNode set as Layer D
After a little more testing, it is not consistent that it will play the tail of the first cut and then onto the next cart. I haven't discovered the actual sequence that makes it happen. Is there a reason why the system doesn't fire carts on GPIO. I have tried on all 3 devices without any success. Either using physical contacts, virtual or rmlsend. Thanks John On Tue, Nov 19, 2019 at 8:02 AM Fred Gleason <[email protected]> wrote: > On Nov 16, 2019, at 10:48, John Boles <[email protected]> wrote: > > While trying to figure out why my macro carts are not firing through LWRP > GPI either physical contact closure or virtual. > I Figured I would setup the GPI in RDAirplay for start and stop and see if > that worked. > And it does. It starts and stops the stack. > > However this is the issue: When I start the stack via GPI it plays the > top cart for the manual transition time and then fires the next cart. Not > the behaviour I would expect. > Wondering if someone can confirm this sequence. > > > That certainly doesn’t sound right. What settings GPIO settings are you > using? > > Cheers! > > > |---------------------------------------------------------------------| > | Frederick F. Gleason, Jr. | Chief Developer | > | | Paravel Systems | > |---------------------------------------------------------------------| > | A room without books is like a body without a soul. | > | | > | -- Cicero | > |---------------------------------------------------------------------| >
_______________________________________________ Rivendell-dev mailing list [email protected] http://caspian.paravelsystems.com/mailman/listinfo/rivendell-dev
