Hello all,
Am bataie de cap cu o placa de retea onboard (placa de baza e un 8IPE775-G de
la Gigabyte).
# lspci |grep Ether
02:09.0 Ethernet controller: Marvell Technology Group Ltd. 88E8001 Gigabit
Ethernet Controller (rev 13)
Folosesc Ceontos4 si cu driverul din kernelul default nu a mers. Am luat si
versiunea unsuported (2.6.9-34.107.plus.c4smp) si tot la fel. In final, am
descarcat driverul de la Marvell de pe site, l-am instalat, placa a inceput
sa functioneze dar merge prost (daca nu se face trafic prin ea).
In dmesg vad urmatoarele:
sk98lin: no version for "struct_module" found: kernel tainted.
ACPI: PCI interrupt 0000:02:09.0[A] -> GSI 20 (level, low) -> IRQ 22
sk98lin: Network Device Driver v8.40.2.3
(C)Copyright 1999-2006 Marvell(R).
eth0: -- ERROR --
Class: Hardware failure
Nr: 0x264
Msg: Unexpected IRQ Status error
eth0: -- ERROR --
Class: Hardware failure
Nr: 0x264
Msg: Unexpected IRQ Status error
si undeva mai la final:
eth0: network connection up using port A
speed: 100
autonegotiation: yes
duplex mode: full
flowctrl: symmetric
irq moderation: disabled
scatter-gather: enabled
tx-checksum: enabled
rx-checksum: enabled
rx-polling: enabled
Dupa citeva minute de functionare, driverul crapa. O ia din nou, la un service
network restart. Am vazut ca nu mai crapa daca las o sonda ping sa mearga in
background.
Va rog sa-mi spuneti (cei care aveti astfel de placi) cum functioneaza la voi
(pe kernel 2.6) si daca exista o solutie de a o face sa functioneze ok (in
afara celei de a o dezactiva din BIOS si a folosi o placa de retea externa).
Alex
_______________________________________________
RLUG mailing list
[email protected]
http://lists.lug.ro/mailman/listinfo/rlug
