On Thu, Feb 22, 2001 at 07:26:17PM +0200, Stefan Laudat wrote:
> <afront direct>
> well, tineretile mele petrecute pe IRC si nu ca altii in vi sau in orice
> alt editor in care se scrie cod sursa zic fix pe dos.
> </afront direct>
Well, se pare ca e mai util sa-ti petreci timpul in editor <wink> :)
Citat din http://www.irchelp.org/irchelp/rfc/ctcpspec.html, Appendix A:
"""
The following are the steps which should occur in the clients
(this description assumes use of the BSD socket interface on a UNIX
system).
Initiator:
DCC command issued.
Create a socket, bind it to INADDR_ANY, port 0, and
make it passive (a listening socket).
Send the recipient a DCC request via CTCP supplying
the address and port of the socket. (This
is ideally taken from the address of the local
side of the socket which is connected to a
server. This is presumably the interface on
the host which is closest to the rest of
the net, and results in one less routing hop
in the case of gateway nodes).
Continue normally until a connection is received.
On a connection:
Accept the connection.
Close the original passive socket.
Conduct transaction on the new socket.
Acceptor:
CTCP DCC request received.
Record information on the DCC request and notify the user.
At this point, the USER should be able to abort (close) the
request, or accept it. The request should be accepted with
a command specifying the sender, type, and argument, or
a subset of these where no ambiguity exists.
If accepted, create a TCP socket.
Connect the new socket to the address and port supplied.
Conduct the transaction over the socket.
"""
--
Petru Paler, mailto:[EMAIL PROTECTED]
http://www.ppetru.net - ICQ: 41817235
---
Send e-mail to '[EMAIL PROTECTED]' with 'unsubscribe rlug' to
unsubscribe from this list.
