> Daca tot da eroare, vezi cu dmesg ce zice kernelul
IRQ to pin mappings:
IRQ0 -> 0:2
IRQ1 -> 0:1
IRQ3 -> 0:3
IRQ4 -> 0:4
IRQ5 -> 0:5
IRQ6 -> 0:6
IRQ7 -> 0:7
IRQ8 -> 0:8
IRQ9 -> 0:9
IRQ10 -> 0:10
IRQ11 -> 0:11
IRQ12 -> 0:12
IRQ13 -> 0:13
IRQ14 -> 0:14
IRQ15 -> 0:15
.................................... done.
Using local APIC timer interrupts.
calibrating APIC timer ...
..... CPU clock speed is 2000.0586 MHz.
..... host bus clock speed is 100.0028 MHz.
cpu: 0, clocks: 1000028, slice: 200005
CPU0<T0:1000016,T1:800000,D:11,S:200005,C:1000028>
cpu: 2, clocks: 1000028, slice: 200005
cpu: 3, clocks: 1000028, slice: 200005
cpu: 1, clocks: 1000028, slice: 200005
CPU3<T0:1000016,T1:199984,D:12,S:200005,C:1000028>
CPU1<T0:1000016,T1:600000,D:6,S:200005,C:1000028>
CPU2<T0:1000016,T1:400000,D:1,S:200005,C:1000028>
checking TSC synchronization across CPUs: passed.
migration_task 0 on cpu=0
migration_task 1 on cpu=1
migration_task 2 on cpu=2
migration_task 3 on cpu=3
mtrr: your CPUs had inconsistent fixed MTRR settings
mtrr: probably your BIOS does not setup all CPUs
ACPI: Subsystem revision 20030228
ACPI: Disabled via command line (acpi=off)
PCI: PCI BIOS revision 2.10 entry at 0xf0094, last bus=16
PCI: Using configuration type 1
PCI: Probing PCI hardware
PCI: ACPI tables contain no PCI IRQ routing entries
PCI: Probing PCI hardware (bus 00)
PCI: Discovered peer bus 01
PCI: Discovered peer bus 05
PCI: Discovered peer bus 09
PCI: Device 00:00 not found by BIOS
PCI: Device 00:01 not found by BIOS
PCI: Device 00:02 not found by BIOS
PCI: Device 00:03 not found by BIOS
PCI: Device 00:78 not found by BIOS
PCI: Device 00:7b not found by BIOS
PCI: Device 00:80 not found by BIOS
PCI: Device 00:82 not found by BIOS
PCI: Device 00:88 not found by BIOS
PCI: Device 00:8a not found by BIOS
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
apm: BIOS not found.
mxt_scan_bios: enter
Starting kswapd
bigpage subsystem: allocated 0 bigpages (=0MB).
allocated 32 pages and 32 bhs reserved for the highmem bounces
kinoded started
VFS: Disk quotas vdquot_6.5.1
aio_setup: num_physpages = 163838
aio_setup: sizeof(struct page) = 48
vesafb: framebuffer at 0xf6000000, mapped to 0xf880d000, size 8128k
vesafb: mode is 1280x1024x16, linelength=2560, pages=2
vesafb: protected mode interface info at c000:4a2e
vesafb: scrolling: redraw
vesafb: directcolor: size=0:5:6:5, shift=0:11:5:0
mtrr: type mismatch for f6000000,400000 old: uncachable new: write-combining
mtrr: type mismatch for f6000000,200000 old: uncachable new: write-combining
mtrr: type mismatch for f6000000,100000 old: uncachable new: write-combining
mtrr: type mismatch for f6000000,80000 old: uncachable new: write-combining
mtrr: type mismatch for f6000000,40000 old: uncachable new: write-combining
mtrr: type mismatch for f6000000,20000 old: uncachable new: write-combining
mtrr: type mismatch for f6000000,10000 old: uncachable new: write-combining
mtrr: type mismatch for f6000000,8000 old: uncachable new: write-combining
mtrr: type mismatch for f6000000,4000 old: uncachable new: write-combining
mtrr: type mismatch for f6000000,2000 old: uncachable new: write-combining
mtrr: type mismatch for f6000000,1000 old: uncachable new: write-combining
mtrr: size and base must be multiples of 4 kiB
mtrr: size: 0x800 base: 0xf6000000
mtrr: size and base must be multiples of 4 kiB
mtrr: size: 0x400 base: 0xf6000000
mtrr: size and base must be multiples of 4 kiB
mtrr: size: 0x200 base: 0xf6000000
mtrr: size and base must be multiples of 4 kiB
mtrr: size: 0x100 base: 0xf6000000
mtrr: size and base must be multiples of 4 kiB
mtrr: size: 0x80 base: 0xf6000000
mtrr: size and base must be multiples of 4 kiB
mtrr: size: 0x40 base: 0xf6000000
mtrr: size and base must be multiples of 4 kiB
mtrr: size: 0x20 base: 0xf6000000
mtrr: size and base must be multiples of 4 kiB
mtrr: size: 0x10 base: 0xf6000000
mtrr: size and base must be multiples of 4 kiB
mtrr: size: 0x8 base: 0xf6000000
mtrr: size and base must be multiples of 4 kiB
mtrr: size: 0x4 base: 0xf6000000
mtrr: size and base must be multiples of 4 kiB
mtrr: size: 0x2 base: 0xf6000000
mtrr: size and base must be multiples of 4 kiB
mtrr: size: 0x1 base: 0xf6000000
Looking for splash picture.... silenjpeg size 43799 bytes, found (1280x1024,
32818 bytes, v3).
Got silent jpeg.
Got silent jpeg.
Console: switching to colour frame buffer device 148x51
fb0: VESA VGA frame buffer device
pty: 256 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with HUB-6 MANY_PORTS MULTIPORT
SHARE_IRQ SERIAL_PCI enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
ttyS01 at 0x02f8 (irq = 3) is a 16550A
Real Time Clock Driver v1.10e
Floppy drive(s): fd0 is 1.44M
FDC 0 is a National Semiconductor PC87306
RAMDISK driver initialized: 16 RAM disks of 64000K size 1024 blocksize
loop: loaded (max 16 devices)
Uniform Multi-Platform E-IDE driver Revision: 7.00beta-2.4
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
SvrWks CSB5: IDE controller at PCI slot 00:0f.1
SvrWks CSB5: chipset revision 147
SvrWks CSB5: not 100% native mode: will probe irqs later
SvrWks CSB5: simplex device: DMA forced
ide0: BM-DMA at 0x2000-0x2007, BIOS settings: hda:pio, hdb:pio
SvrWks CSB5: simplex device: DMA forced
ide1: BM-DMA at 0x2008-0x200f, BIOS settings: hdc:DMA, hdd:DMA
hda: COMPAQ CD-ROM SC-148C, ATAPI CD/DVD-ROM drive
hda: set_drive_speed_status: status=0x51 { DriveReady SeekComplete Error }
hda: set_drive_speed_status: error=0x04
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide-floppy driver 0.99.newide
ide-floppy driver 0.99.newide
SCSI subsystem driver Revision: 1.00
kmod: failed to exec /sbin/modprobe -s -k scsi_hostadapter, errno = 2
md: md driver 0.90.0 MAX_MD_DEVS=256, MD_SB_DISKS=27
md: Autodetecting RAID arrays.
md: autorun ...
md: ... autorun DONE.
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 32768 buckets, 256Kbytes
TCP: Hash tables configured (established 262144 bind 65536)
Linux IP multicast router 0.06 plus PIM-SM
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
RAMDISK: Compressed image found at block 0
Freeing initrd memory: 612k freed
VFS: Mounted root (ext2 filesystem).
scsi0 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.29
<Adaptec (Compaq OEM) 3960D Ultra160 SCSI adapter>
aic7899: Ultra160 Wide Channel A, SCSI Id=7, 32/253 SCBs
scsi1 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.29
<Adaptec (Compaq OEM) 3960D Ultra160 SCSI adapter>
aic7899: Ultra160 Wide Channel B, SCSI Id=7, 32/253 SCBs
blk: queue c3979618, I/O limit 524287Mb (mask 0x7fffffffff)
(scsi0:A:6): 20.000MB/s transfers (10.000MHz, offset 15, 16bit)
Vendor: COMPAQ Model: DLT8000 Rev: 0255
Type: Sequential-Access ANSI SCSI revision: 02
blk: queue f7fc2e18, I/O limit 524287Mb (mask 0x7fffffffff)
HP CISS Driver (v 2.4.44)
cciss: Device 0xb060 has been found at bus 1 dev 1 func 0
cciss: using DAC cycles
blocks= 426784320 block_size= 512
heads= 255, sectors= 32, cylinders= 52302 RAID 5
blk: queue c0437da0, I/O limit 4294967295Mb (mask 0xffffffffffffffff)
Partition check:
cciss/c0d0: p1 p2
reiserfs: found format "3.6" with standard journal
reiserfs: enabling write barrier flush mode
reiserfs: using ordered data mode
reiserfs: checking transaction log (cciss0(104,2)) for (cciss0(104,2))
Using r5 hash to sort names
VFS: Mounted root (reiserfs filesystem) readonly.
Trying to move old root to /initrd ... failed
Unmounting old root
Trying to free ramdisk memory ... okay
Freeing unused kernel memory: 184k freed
md: Autodetecting RAID arrays.
md: autorun ...
md: ... autorun DONE.
Adding Swap: 1052616k swap-space (priority 42)
Intel(R) PRO/100 Network Driver - version 2.1.29-k3
Copyright (c) 2002 Intel Corporation
e100: selftest OK.
e100: eth0: Compaq Fast Ethernet Server Adapter
Hardware receive checksums enabled
cpu cycle saver enabled
raw1394: /dev/raw1394 device initialized
e100: eth0 NIC Link is Up 100 Mbps Full duplex
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
usb-uhci.c: $Revision: 1.275 $ time 11:35:53 Dec 3 2003
usb-uhci.c: High bandwidth mode enabled
usb-uhci.c: v1.275:USB Universal Host Controller Interface driver
uhci.c: USB Universal Host Controller Interface driver v1.1
usb-ohci.c: USB OHCI at membase 0xf915d000, IRQ 10
usb-ohci.c: usb-00:0f.2, ServerWorks OSB4/CSB5 OHCI USB Controller
usb.c: new USB bus registered, assigned bus number 1
hub.c: USB hub found
hub.c: 4 ports detected
mice: PS/2 mouse device common for all mice
st: Version 20020805, bufsize 32768, wrt 30720, max init. bufs 4, s/g segs
16
Attached scsi tape st0 at scsi0, channel 0, id 6, lun 0
st0: Block limits 2 - 16777214 bytes.
IPv6 v0.8 for NET4.0
IPv6 over IPv4 tunneling driver
isapnp: Scanning for PnP cards...
isapnp: No Plug & Play device found
mtrr: type mismatch for f6000000,800000 old: uncachable new: write-combining
mtrr: type mismatch for f6000000,800000 old: uncachable new: write-combining
Linux video capture interface: v1.00
eth0: no IPv6 routers present
magics:/home/cristiv #
---
Detalii despre listele noastre de mail: http://www.lug.ro/
