Alin Osan wrote:
>On 6/14/05, lonely wolf <[EMAIL PROTECTED]> wrote:
>
>
>>Alin Osan wrote:
>>
>>
>>
>>>Salutare,
>>>
>>>Desi nu credeam sa mai vina ziua in care sa folosesc dial-up, am ajuns
>>>din nou la dial-up, cel putin temporar.
>>>As dori sa stiu daca pot configura kppp (sau un script de login) care
>>>sa faca urmatoarele:
>>>
>>>3423354354#
>>>wait 10 sec
>>>23425345534#
>>>conectare
>>>
>>>
>>>
>>>
>>atdt3423354354#,23425345534#
>>
>>perioada implicita cit asteapta modemul la ',' este configurabila
>>dintr-un registru al acestuia, vezi in documentatie care e registrul si
>>ce valoare trebuie pusa pentru 10 sec
>>
>>
>
>Super multumesc.
>Documentatia indicata este de kppp sau de pppd?
>
>
nici nici. "," si "W" sint comanzi standard pt orice modem compatibil
hayes. merg cu orice aplicatie care "suna" pt ca de fapt sint
independente de aplicatie.
recitind primul raspuns: daca nu stie modemul sa stea 10 sec din o
singura virgula, se pot introduce mai multe, la stilul
atdt3423354354#,,,23425345534#
pt fiecare virgula va sta perioada specificata de acel registru S.
>
>
>>ca obs: exista si comanda W "Wait for dial-tone" (probabil inutila in
>>cazul tau specific, dar folositoare cind treci printr-un PBX care zice
>>'formeaza 0 pentru a obtine ton de oras')
>>
>>
>
>Orice alte informatii suplimentare (link-uri si mai bine) sunt bine venite.
>
>
http://www.modemhelp.net/basicatcommand.shtml#COMMA :
*, - "Pause" - The Comma normally initiates a 1-5 second pause,
however is sometimes used as a command separator in +MS and other commands.
*
*AT - "Attention! <http://www.modemhelp.net/basicatcommand.shtml#AT>"*
*+++ - "Escape Sequence
<http://www.modemhelp.net/basicatcommand.shtml#PLUS>"*
*Dn - "Dial Control" - This command dials the phone number with
accordance to the modifiers of n.*
* DL - Redial the last dialed number*
* DP - Pulse dial*
* DR - Enable answer mode*
* DS=x - Dial the stored telephone number in x*
* DT - Tone dial*
* DW - Resume dialing after dial tone is detected*
* D, - Pause before dial*
*Sn=x - "Status Registers" - This command writes to or reads data
from S-register n. The data written is represented in the place of x.
The data used in read mode is selected by the value in x. S-registers
can vary a great deal, please consult the AT Command Set specific to
your modem when attempting to use these.*
---
Detalii despre listele noastre de mail: http://www.lug.ro/
