Hi all (but mostly Linus), I'm having troubles accessing the isp1362 chip in the H3x0. I've mapped its CS to 0x30000000 and tried several options in CSCR3 (no success).
I wonder about this: - MCF5249 users manual page 172, in table 10-9 about the PS[1:0] CS select bit description there is a note: "A0 is not available on the external bus". If so, I wonder where A0 and A1 of the isp1362 are connected to. - the isp1362 datasheet on page 49 (point 12.9) talks about the powermanagement, and mentions two pins that must be pulled low to enable device and host part of the chip respectively. So they are probably connected to the GPIO? The two pins should be tied to vcc using a resistor. Or I don't understand that part :( fyi, A0 is pin 61, A1 is pin 62 shall I put the code I have so far somewhere? thnx, Peter
