[Rodopi] Netflow Addresses

[Ken Richardson]

Title: Message

OK, I give up. Can someone please send me the RegEx that they use for getting this to work.   I've tried without much luck to get this going.   Thanks   Ken! -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Suneel Jhangiani Sent: Wednesday, August 06, 2003 9:27 PM To: [EMAIL PROTECTED] Subject: [Rodopi] Netflow Addresses There is an error in the default Rodopi RegEx for IPv4 addresses. You need to modify this to allow the last octet to be greater.   Regards,   Suneel   From: Ken Richardson [mailto:[EMAIL PROTECTED] Sent: 06 August 2003 00:34 To: [EMAIL PROTECTED]   Hi   I've encountered a problem with entering IP addresses into a Netflow plan. I can use pretty much any IP address I like, so long as the last Octect is less than 200.   eg I can enter 192.168.100.199, but if I enter 192.168.100.200 I get the following error message   "NetFlow IP Address : IPv4 Mask is valid IPv4 address with (optionaly) % as wildcard in last number)"   I have had a look at the Item Formats for this and cannot for the life of me figure it out? We are running v5.1SP2.   Anyone encountered this previously?   Thanks ........................................................................................ Ken Richardson Senior Systems Engineer Daltron Electronics Limited P.O. Box 1711, Boroko, PNG Tel: +675 302 2200 Fax: +675 325 6558 Email: [EMAIL PROTECTED] Web Site: www.daltron.com.pg ........................................................................................