Hi Anthony,
> When I use state transition lines with the horizontal > synchronization bars > the line alway begin or end from the center of the bar. I have seen > diagrams where the transitions lines begin from any point on > the bar and end > at any place on the lower bar. How is this accoplished? > > Thanks for any help anyone can provide. I think you should try selecting the line and pressing the following key combination: ctrl-shift-l Greetings, Arno Leenders ----------------------------------------------------------------- ATTENTION: No legal consequences can be derived from the content of this e-mail and/or its attachments. Neither is sender committed to these. The content of this e-mail is exclusively intended for addressee(s) and information purposes. Should you receive this message by mistake, you are hereby notified that any disclosure, reproduction, distribution or use of this message is strictly prohibited. Sender accepts no liability for any damage resulting from the use and/or acceptation of the content of this e-mail. Always scan attachments for viruses before opening them. ----------------------------------------------------------------- ************************************************************************ * Rose Forum is a public venue for ideas and discussions. * For technical support, visit http://www.rational.com/support * * Post or Reply to: [EMAIL PROTECTED] * Subscription Requests: [EMAIL PROTECTED] * Archive of messages: * http://www.rational.com/support/usergroups/rose/rose_forum.jsp * Other Requests: [EMAIL PROTECTED] * * To unsubscribe from the list, please send email * To: [EMAIL PROTECTED] * Subject: <BLANK> * Body: unsubscribe rose_forum *************************************************************************
