Josh, Please RTFM...you should know this one...
put a / 10 after the target ip address and you will have the right answer... Paul >>> "Josh Goldfarb" <[EMAIL PROTECTED]> 05/24/01 11:18AM >>> Just curious if this can be done in MRTG. For instance, As you know, electrical current is measured in amps. Depending upon which phase you look at, we are actually using between 20 and 60 amps. However, MRTG shows that we are using from 200 to 600 amps. The MRTG values are the correct ones, but multiplied by 10. So, what needs to be done is for you to tell MRTG to divide the values by 10 before it graphs them. Is that possible in MRTG or is RRDTOOL the solution for this problem below is a snipIT from my config file! Target[Kodiak_Load]: 1.3.6.1.4.1.318.1.1.1.9.3.3.1.7.1.1.1&1.3.6.1.4.1.318.1.1.1.9.3.3.1.7.1. 1.1:[EMAIL PROTECTED] <mailto:1.3.6.1.4.1.318.1.1.1.9.3.3.1.7.1.1.1&1.3.6.1.4.1.318.1.1.1.9.3. 3.1.7.1.1.1:[EMAIL PROTECTED]> MaxBytes[Kodiak_Load]: 7500 Title[Kodiak_Load]: Phase 1/2 Output Load PageTop[Kodiak_Load]: <H1>Phase 1/2 Output Load</H1> Options[Kodiak_Load]: gauge, nopercent, absolute Unscaled[Kodiak_Load]: dwmy #Supress[[Kodiak_Load]: dwmy XSize[Kodiak_Load]: 400 YSize[Kodiak_Load]: 100 YLegend[Kodiak_Load]: Output Load ShortLegend[Kodiak_Load]: kVA LegendI[Kodiak_Load]: Output Load LegendO[Kodiak_Load]: Thanks in advance -- Unsubscribe mailto:[EMAIL PROTECTED] elp mailto:[EMAIL PROTECTED] Archive http://www.ee.ethz.ch/~slist/rrd-users WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi -- Unsubscribe mailto:[EMAIL PROTECTED] Help mailto:[EMAIL PROTECTED] Archive http://www.ee.ethz.ch/~slist/rrd-users WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi
