Haven't tried it, but off hand one thing I would check would be to make sure that you have set the "bandwidth xxx" command on the sub-inteface
Mike Fountain, CCNP
Sr. Network Engineer, Worldspan
[EMAIL PROTECTED]
770-563-7606
Francisco Rivas C
<[EMAIL PROTECTED] To: Rrd-Users
<[email protected]>
w.cl> cc:
Sent by: Subject: [rrd-users] data
fetching from a Cisco 7206VXR
[EMAIL PROTECTED] with 802.1q interfaces?
.ee.ethz.ch
11/18/2002 01:28 PM
Hi,
has anyone tried to get data from the 802.1q interfaces in a Cisco
router??
The latest IOS reports the sub-interfaces, and it can be monitored
through SNMP. But, the reported values are too high.. 10MB on a 512k
interface?? anyone has seen this behavior before??
I'm using the latest RRD, and I've tried with MRTG too, but the results
are the same...
Francisco R.
--
Unsubscribe mailto:[EMAIL PROTECTED]
Help mailto:[EMAIL PROTECTED]
Archive http://www.ee.ethz.ch/~slist/rrd-users
WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi
--
Unsubscribe mailto:[EMAIL PROTECTED]
Help mailto:[EMAIL PROTECTED]
Archive http://www.ee.ethz.ch/~slist/rrd-users
WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi
