Note that the catalyst switch must have the info for its snmp agent configured, and the agent must be enabled. You also want to be sure that the snmp write passwords are set to some good password (or snmp writes disabled), as that can be a huge security problem.
Cisco's website will provide you with the instructions on how to do this. Connie Logg - Network Analyst Stanford Linear Accelerator Center 2575 Sand Hill Road, Menlo Park, CA 94025 650-926-2879, [EMAIL PROTECTED] "If is the middle word in life, but happiness is found along the way, not at the end of the road." -----Original Message----- From: brascon [mailto:[EMAIL PROTECTED] Sent: Wednesday, November 05, 2003 1:39 AM To: rrd-users list Subject: [rrd-users] mrtg monitoring catalyst switch Hi, I have MRTG installed in a PC trying to monitor everything connected to a Cisco catalyst 4000, I get absolutely nothing but the following error message: C:\mrtg-2.10.5\bin>perl cfgmaker [EMAIL PROTECTED] --global "WorkDir: c:\www \mrtg" --output mrtg.cfg --base: Get Device Info on [EMAIL PROTECTED]: SNMP Error: no response received SNMPv1_Session (remote host: "192.168.11.254" [192.168.11.254].161) community: "public" request ID: -1855272305 PDU bufsize: 8000 bytes timeout: 2s retries: 5 backoff: 1) at C:/mrtg-2.10.5/bin\..\lib\mrtg2/SNMP_util.pm line 621 SNMPWALK Problem for 1.3.6.1.2.1.1 on [EMAIL PROTECTED]::::::v4only at cfgmaker line 775 WARNING: Skipping [EMAIL PROTECTED]: as no info could be retreived --base: Writing mrtg.cfg I know nothing about these switches, what do i have to add to the catalyst to get mrtg to collect info? many thanks, bg -- Unsubscribe mailto:[EMAIL PROTECTED] Help mailto:[EMAIL PROTECTED] Archive http://www.ee.ethz.ch/~slist/rrd-users WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi -- Unsubscribe mailto:[EMAIL PROTECTED] Help mailto:[EMAIL PROTECTED] Archive http://www.ee.ethz.ch/~slist/rrd-users WebAdmin http://www.ee.ethz.ch/~slist/lsg2.cgi
