Committed. thanks
On Wed, Jan 15, 2014 at 10:37 PM, Nick Withers <nick.with...@anu.edu.au> wrote: > Hi all, > > The attached patch adds a "WARNING" note to MOTLoad-equipped BSPs' > READMEs [1] that a "waitProbe", "netShut" must be performed before RTEMS > boot. > > If this isn't done, MOTLoad's installed interrupt handlers for network > interfaces will continue to be triggered and cause memory corruption. > The "waitProbe" will add a delay to ensure that devices have been > detected; otherwise the "netShut" may be performed before all the > interfaces are detected and there's a race between their detection + > interrupt handler installation and the user-image boot. > > I've already added a note to the same effect to these boards' Wiki > pages. > > Thanks to Sebastian Huber for helping me correct an earlier > mis-diagnosis of the issue and Till Straumann for checking it. > > If there're no objections I'd like to send out a message to rtems-users@ > pointing to the warnings once they're committed...? > > [1] I modified those for the Beatnik, MVME3100 and MVME5500 BSPs. Did I > miss any? > -- > Nick Withers > > Embedded Systems Programmer > Room 2.26, Building 57 > Department of Nuclear Physics > Research School of Physics and Engineering > The Australian National University (CRICOS: 00120C) > > eMail: nick.with...@anu.edu.au > Phone: +61 2 6125 2091 > Mobile: +61 414 397 446 > > _______________________________________________ > rtems-devel mailing list > rtems-devel@rtems.org > http://www.rtems.org/mailman/listinfo/rtems-devel > _______________________________________________ rtems-devel mailing list rtems-devel@rtems.org http://www.rtems.org/mailman/listinfo/rtems-devel
