Chris, I can use OpenOCD to load, run, break, resume, etc, but I am not having luck with GDB yet.
I can connect to the OpenOCD remote target server, send monitor commands, but I cannot load code through GDB or control the target. When I try loading through GDB, I end up with load failure messages. Any hints in configuring OpenOCD or GDB? Thanks, Alan On Mon, Apr 28, 2014 at 8:55 PM, Chris Johns <chr...@rtems.org> wrote: > On 29/04/2014 10:37 am, Alan Cudmore wrote: > >> I will definitely try that out. It would be great to automate all tests >> on this board. >> It seems less than 10 seconds to load a 1 megabyte RTEMS image to the Pi >> using JTAG. >> >> > The last test from the Beagleboard xM test log shows ... > > [498/498] p:488 f:1 t:8 i:0 | arm/beagleboardxm: tmoverhd.exe > Result: passed Time: 0:00:12.141110 > > This test took just over 12 seconds so this seems close to what we have. > > Chris >
_______________________________________________ rtems-devel mailing list rtems-devel@rtems.org http://www.rtems.org/mailman/listinfo/rtems-devel
