Hi Ketan, Thank you for sharing your interpretation of the introduced text. I agree that your view is in line with how the scope of BFD is defined in RFC 5880:
protocol intended to detect faults in the bidirectional path between two forwarding engines, including interfaces, data link(s), and to the extent possible the forwarding engines themselves But it is not clear to me how "liveness of a node" is retated to the definition above. I hope thr Authors will clarify that for me. Regards, Greg On Tue, Sep 26, 2023, 09:56 Ketan Talaulikar <[email protected]> wrote: > Hi Greg, > > I would read it as " ... the liveness of a node over the specific > interface ..." i.e, the node is reachable and responding over that > interface. > > Thanks, > Ketan > > > On Tue, Sep 26, 2023 at 7:16 PM Greg Mirsky <[email protected]> wrote: > >> Hi, >> as I understand it, the update assigns to the Unaffiliated BFD a new >> functionality, monitoring "the liveness of a node not including the >> availability of a specific IP address at that node". In my opinion, that >> raises some questions: >> >> - What is "the liveness of a node"? >> - When referring to the liveness of a node, does it applicable to >> a single-box system or also to a virtual, distributed, e.g., the one using >> the CUPS paradigm? >> - How the liveness of a node is derived from the functionality of a >> single interface? Is it equally applicable regardless the interface is >> physical or virtual? >> >> Thank you for your consideration. >> >> Regards, >> Greg >> >> On Tue, Sep 26, 2023 at 5:38 AM Ketan Talaulikar <[email protected]> >> wrote: >> >>> Thanks Xiao Min - the update looks good and addresses my comments. >>> >>> Thanks, >>> Ketan >>> >>> On Tue, Sep 26, 2023 at 12:58 PM <[email protected]> wrote: >>> >>>> Hi Ketan, >>>> >>>> >>>> Thank you for the suggested text, very helpful. >>>> >>>> I've just posted a new revision that incorporates all your comments. >>>> Link as below. >>>> >>>> >>>> <https://datatracker.ietf.org/doc/html/draft-ietf-bfd-unaffiliated-echo-09> >>>> https://datatracker.ietf.org/doc/html/draft-ietf-bfd-unaffiliated-echo-09 >>>> >>>> >>>> <https://datatracker.ietf.org/doc/html/draft-ietf-bfd-unaffiliated-echo-09>Please >>>> see inline with [XM-2]>>>. >>>> Original >>>> *From: *KetanTalaulikar <[email protected]> >>>> *To: *肖敏10093570; >>>> *Cc: *[email protected] < >>>> [email protected]>;[email protected] < >>>> [email protected]>;[email protected] <[email protected]>; >>>> *Date: *2023年09月25日 15:37 >>>> *Subject: **Re: Comments on draft-ietf-bfd-unaffiliated-echo-08* >>>> Hi Xiao Min, >>>> Thanks for your response. Please check inline below for further >>>> suggestions. >>>> >>>> On Mon, Sep 25, 2023 at 11:41 AM <[email protected]> wrote: >>>> >>>>> Dear Ketan, >>>>> >>>>> >>>>> Thanks for your review and thoughtful comments. >>>>> Please see inline. >>>>> Original >>>>> *From: *KetanTalaulikar <[email protected]> >>>>> *To: *[email protected] < >>>>> [email protected]>; >>>>> *Cc: *[email protected] <[email protected]>;Jeffrey Haas <[email protected] >>>>> >; >>>>> *Date: *2023年09月22日 22:55 >>>>> *Subject: **Comments on draft-ietf-bfd-unaffiliated-echo-08* >>>>> Hello Authors, >>>>> >>>>> Looks like I've missed the WGLC on this document, but nevertheless >>>>> would like to share the following comments: >>>>> >>>>> Sec 1 of the document says: >>>>> >>>>> Section 5 of [RFC5880 >>>>> <https://www.ietf.org/archive/id/draft-ietf-bfd-unaffiliated-echo-08.html#RFC5880> >>>>> ] indicates that the payload of an affiliated BFD Echo packet is a >>>>> local matter and hence its contents are outside the scope of that >>>>> specification. This document, on the other hand, specifies the contents of >>>>> the Unaffiliated BFD Echo packet and what to do with them. >>>>> >>>>> However, when I go through the procedures in Section 2, there is no >>>>> description of the actual construction of the IP packet that A sends out >>>>> to >>>>> B - what is the source and destination IP - or MAC addresses for that >>>>> matter? How is it that B would loop it back? I believe it is important for >>>>> the document to specify this. >>>>> >>>>> [XM]>>> This document does specify the source and destination IP, >>>>> through reference to RFC 5881. In section 2 it says >>>>> >>>>> "Regarding the selection of IP address, the rules stated in Section 4 >>>>> of [RFC5881 <https://www.rfc-editor.org/info/rfc5881>] are applicable >>>>> to the encapsulation of an Unaffiliated BFD Echo packet." >>>>> >>>>> In -07 version the rules of RFC 5881 were restated, however in -08 >>>>> version they're removed by following the suggestion from Greg. >>>>> >>>> KT> I missed that conversation. One small suggestion so it covers not >>>> just IP address but also MAC. >>>> >>>> OLD: Regarding the selection of IP address, the rules stated in >>>> Section 4 of [RFC5881 >>>> <https://www.ietf.org/archive/id/draft-ietf-bfd-unaffiliated-echo-08.html#RFC5881> >>>> ] are applicable to the encapsulation of an Unaffiliated BFD Echo >>>> packet. >>>> >>>> NEW: An Unaffiliated BFD Echo packet follows the same encapsulation >>>> rules as for a BFD Echo packet as specified in Section 4 of [RFC5881 >>>> <https://www.ietf.org/archive/id/draft-ietf-bfd-unaffiliated-echo-08.html#RFC5881> >>>> ]. >>>> >>>> [XM-2]>>> Accepted. >>>> >>>> >>>> >>>>> Another important part is that normally BFD verifies the bidirectional >>>>> path, the liveness of the other endpoint, but also validates the presence >>>>> of a specific IP at that endpoint. Is that still the case when operating >>>>> in >>>>> this mode? This question arises since the document talks about liveness to >>>>> servers - so is it monitoring liveness to the server host or a specific >>>>> server IP? >>>>> >>>>> [XM]>>> It's monitoring liveness to the server host, not a specific >>>>> server IP. Also note that the Unaffiliated BFD Echo can be used for >>>>> multiple use cases, in section 1 it says >>>>> >>>>> "Section 6.2.2 of [BBF-TR-146 >>>>> <https://www.broadband-forum.org/technical/download/TR-146.pdf>] describes >>>>> one use case of the Unaffiliated BFD Echo. Section 2 of [ >>>>> I-D.wang-bfd-one-arm-use-case >>>>> <https://datatracker.ietf.org/doc/html/draft-wang-bfd-one-arm-use-case-00> >>>>> ] describes another use case of the Unaffiliated BFD Echo." >>>>> >>>> KT> This is OK. I was looking for some text (perhaps in Section 1) that >>>> says something on the lines of ... "The Unaffiliated BFD Echo functionality >>>> only monitors liveness of the node and does not monitor the availability of >>>> a specific IP address at that node." - I believe this is an important >>>> distinction from normal BFD operations that needs to be called out. Would >>>> you agree? >>>> >>>> [XM-2]>>> Some text as you want was added to section 1. >>>> >>>>> >>>>> Finally, is it normal or natural to expect server hosts to be able to >>>>> "loop them back by normal IP forwarding"? Or does it require some >>>>> additional/special capabilities to be turned ON those hosts as hosts don't >>>>> do forwarding by default. >>>>> >>>>> [XM]>>> As I know of a deployment, there is no need to turn ON those >>>>> hosts. At the same time, it's feasible to have such a knob. Propose to add >>>>> some text as below. >>>>> >>>>> OLD >>>>> >>>>> The method for provisioning device B to loop back BFD Unaffiliated >>>>> Echo packets is outside the scope of this document. >>>>> >>>>> NEW >>>>> >>>>> There may be a knob to turn on/off the loopback of Unaffiliated BFD >>>>> Echo packets at device B. The method for provisioning device B to >>>>> loop back Unaffiliated BFD Echo packets is outside the scope of this >>>>> document. >>>>> >>>>> >>>>> KT> This is not quite where I was going. Perhaps something on the >>>> following lines? >>>> NEW: >>>> BFD Unaffiliated Echo feature depends on device B performing IP >>>> forwarding (actually IP redirect) functionality. While such functionality >>>> may normally be expected to be supported on a router, it may not be enabled >>>> on a host by default. The method for provisioning device B to loop back BFD >>>> Unaffiliated Echo packets is outside the scope of this document. >>>> >>>> [XM-2]>>> Accepted. >>>> >>>> >>>> Best Regards, >>>> >>>> Xiao Min >>>> >>>> >>>> Thanks, >>>> Ketan >>>> >>>> Best Regards, >>>>> >>>>> Xiao Min >>>>> >>>>> >>>>> It would help if these aspects are clarified in the document. >>>>> >>>>> >>>>> Thanks, >>>>> Ketan >>>>> >>>>> On Thu, Jul 6, 2023 at 7:50 AM <[email protected]> wrote: >>>>> >>>>>> >>>>>> A New Internet-Draft is available from the on-line Internet-Drafts >>>>>> directories. This Internet-Draft is a work item of the Bidirectional >>>>>> Forwarding Detection (BFD) WG of the IETF. >>>>>> >>>>>> Title : Unaffiliated BFD Echo >>>>>> Authors : Weiqiang Cheng >>>>>> Ruixue Wang >>>>>> Xiao Min >>>>>> Reshad Rahman >>>>>> Raj Chetan Boddireddy >>>>>> Filename : draft-ietf-bfd-unaffiliated-echo-08.txt >>>>>> Pages : 12 >>>>>> Date : 2023-07-05 >>>>>> >>>>>> Abstract: >>>>>> Bidirectional Forwarding Detection (BFD) is a fault detection >>>>>> protocol that can quickly determine a communication failure between >>>>>> two forwarding engines. This document proposes a use of the BFD >>>>>> Echo >>>>>> where the local system supports BFD but the neighboring system does >>>>>> not support BFD. BFD Control packet and its processing procedures >>>>>> can be executed over the BFD Echo port where the neighboring system >>>>>> only loops packets back to the local system. >>>>>> >>>>>> This document updates RFC 5880. >>>>>> >>>>>> The IETF datatracker status page for this Internet-Draft is: >>>>>> https://datatracker.ietf.org/doc/draft-ietf-bfd-unaffiliated-echo/ >>>>>> >>>>>> There is also an htmlized version available at: >>>>>> >>>>>> https://datatracker.ietf.org/doc/html/draft-ietf-bfd-unaffiliated-echo-08 >>>>>> >>>>>> A diff from the previous version is available at: >>>>>> >>>>>> https://author-tools.ietf.org/iddiff?url2=draft-ietf-bfd-unaffiliated-echo-08 >>>>>> >>>>>> Internet-Drafts are also available by rsync at rsync.ietf.org: >>>>>> :internet-drafts >>>>>> >>>>>> >>>>>> >>>>> >>>>
