Hi Paolo, thank you for your hint. I have looked at the sourceforge and other places for the newest version and I'm be sure the lateset version is 0.5.4pre2, this one, that I use. Ciao Thomas... -----Ursprungliche Nachricht----- Von: Paolo Mantegazza [mailto:[EMAIL PROTECTED]] Gesendet: Donnerstag, 26. April 2001 09:54 An: [EMAIL PROTECTED]; Thomas Lehwald Betreff: Re: [rtl] rt_com and irq driven receive timing Thomas Lehwald wrote: > > Hi all, > > shame on me!!! I have found the reason why! It's a delay in the hardware of > the chip and is enabled by enabling the hardware fifos! If the threshold for > the receiver irq is not reachead (because only one char arrived and it will > be set i.e. to 8) than an timeout occures to force the receiving interrupt. > May be the delay can depends from the bit clock (baudrate and divider > register), so seen in different delay times. > I think you are using a very old rt_com version. What you mentioned was fixed by Giuseppe Renoldi ([EMAIL PROTECTED]), quite some time ago. I'm sure he sent the fixed version at the rt_com home site. Ciao, Paolo.. -- [rtl] --- To unsubscribe: echo "unsubscribe rtl" | mail [EMAIL PROTECTED] OR echo "unsubscribe rtl <Your_email>" | mail [EMAIL PROTECTED] -- For more information on Real-Time Linux see: http://www.rtlinux.org/rtlinux/ -- [rtl] --- To unsubscribe: echo "unsubscribe rtl" | mail [EMAIL PROTECTED] OR echo "unsubscribe rtl <Your_email>" | mail [EMAIL PROTECTED] -- For more information on Real-Time Linux see: http://www.rtlinux.org/rtlinux/
