Rizzardo Strada wrote: > > Hi, > I'm using for the first time RTnet software with RTAI 3.5. > My PC-based controller has two Ethernet lines handled by the same driver > (8139too). > I need a non real time ethernet line for the normal communications and an > ethernet line for hard real time communication. > > To obtain both drivers working, Roland said to rmmod the non real time > driver, insmod the hard real time driver and then insmod again the non real > time driver. > These are the operation sequence and my problems : > 1) I boot my PC with 2 8139 Ethernet lines > 2) In proc/modules I see 8139too non real time driver > 3) Now : rmmod 8139too . The system doesn't dilsplay anything (but the > 8139too module is still in the /proc/modules list in the first position) > 4) I load all rtnet modules : > .... > ... > insmod rt_8139too cards 0,1,0 (to use the second line, is the > calling syntax correct ?)
cards=0,1,0 > No errors in this operation > 5) Now I try to reload non raltime driver : > insmod 8139too.ko > but the operationg system says that the file already exists. > > What is wrong in this procedure ? > Thank you very much for your help ! > Rizzardo > Jan -- Siemens AG, Corporate Technology, CT SE 2 Corporate Competence Center Embedded Linux ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ RTnet-users mailing list RTnet-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/rtnet-users
