Try the matte urethane spray. I have 150 architectural models out there in the US or 11 other countries that whenever I used wood on anything I sealed it.. No warping ever. The same on wood model rail items.
John Armstrong ----- Original Message ----- From: Thorinn Marty To: Richard Karnes Cc: [email protected] Sent: Wednesday, October 19, 2011 11:33 AM Subject: {S-Scale List} Re: Sealing laser cut buildings Dear Dick: Thank you for the advice. Before I do my next building, I will go and get a can from Home Depot to seal my wood. Your comments about wood and latex (water based) paints have proven to be accurate. I dislike turning flat wood into warped wood. I like water based paints. They lack fumes. Two weeks later the oil based paints are still giving off fumes still make me sick. I love painting with a brush. It is fast -- if I have five minutes, I can brush paint. I normally paint at a workbench in a common room of the house so fumes are a big issue. (I do have an airgun, airbrush, compressor, etc. But I save them for big projects, primers, and orange. Even there I use Poly-S.) Dullcote, and other sprays, are always done outside. I take the time to mount the items for spray painting, carry them outside and spray. A can based paint / shellac / sealer has minimal cleanup. (Compared to an airbrush.) I shall seal the wood sheets in future kits. By hanging the pieces, I can do side one, rotate the piece, and do side two: all in one trip. Both sides will be wet at the same time. After drying I will be painting the sealer, not the wood. Thank you, Thorin ________________________________ From: Richard Karnes <[email protected]> To: "[email protected]" <[email protected]> Sent: Tue, October 18, 2011 11:28:56 PM Subject: Re: Sealing laser cut buildings Thorin -- You're getting a lot of confusing advice. I construct a lot of laser-cut structures both for my layout and for my reviews in "Model Railroad News." My favorite paints come from the Home Depot spray-can section. There is a wide variety of flat and semi-gloss lacquer paint in spray cans. Once dry, the semi-gloss will be nearly flat anyway. But you can always follow up with clear flat once your structure is finished. The lacquer paints will not cause your wood to warp. If you want, you can spray both sides of the frets; the paints dry very rapidly. Paint outdoors!! Do not remove any parts from the frets until you have finished painting. If you have a fret whose parts require more than one color, just mask them. For touching up the edges, spray a small amount of paint into the can's cap and apply with a fine artist's brush. DON'T USE ANY WATER-BASED PAINTS ON THIN WOOD!! Dick Karnes [Non-text portions of this message have been removed] __________ Information from ESET NOD32 Antivirus, version of virus signature database 6557 (20111019) __________ The message was checked by ESET NOD32 Antivirus. http://www.eset.com __________ Information from ESET NOD32 Antivirus, version of virus signature database 6557 (20111019) __________ The message was checked by ESET NOD32 Antivirus. http://www.eset.com [Non-text portions of this message have been removed] ------------------------------------ Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/S-Scale/ <*> Your email settings: Individual Email | Traditional <*> To change settings online go to: http://groups.yahoo.com/group/S-Scale/join (Yahoo! ID required) <*> To change settings via email: [email protected] [email protected] <*> To unsubscribe from this group, send an email to: [email protected] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
