Hi Carey,
I suggest to use a cone wire brush in a dremel on the location that you plan to
solder too. I would not spend time cleaning the intire model. Also clean the
casting carefuly with the dremel brush. I also use purple Scotch Brites.
Funny that I just read this email becuase I just got done cleaning the tender I
have been working on. I first cleaned it with solvent to remove any flux using
a stiff brush similar to a tooth brush. Then a supper duty rubbing compond to
remove any discoloration with heavy paper towels. Then another solvent cleaning
followed by Windex then solvent cleared to stop oxidation. I know it will be a
while I get color on it since I am back on the loco.
Mike Swederska
------------------------------------
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/S-Scale/
<*> Your email settings:
Individual Email | Traditional
<*> To change settings online go to:
http://groups.yahoo.com/group/S-Scale/join
(Yahoo! ID required)
<*> To change settings via email:
[email protected]
[email protected]
<*> To unsubscribe from this group, send an email to:
[email protected]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
