OK, it took about ten minutes with configure --enable-dot2tex=yes Martin On Sunday, 12 October 2025 at 09:38:43 UTC+2 Martin R wrote:
> (for comparison, previously installing dot2tex took just a few seconds) > > On Sunday, 12 October 2025 at 09:36:04 UTC+2 Martin R wrote: > >> On Sunday, 12 October 2025 at 04:14:24 UTC+2 [email protected] wrote: >> >> it might take a lot of time to create the correct list of targets, as you >> don't follow the best way, which is >> >> ./configure --enable-dot2tex=yes >> make # this should also build do2tex >> >> >> I thought that this would be the default (if installed, which it is): >> >> --enable-dot2tex={no|if_installed (default)|yes} >> enable build and use of the optional package >> dot2tex: Create PGF/TikZ >> commands from Graphviz output >> * package info: ./sage -info dot2tex >> >> I'll try anyway. But in fact, that also means that I have to be more >> careful than previously, since there are several packages I only install >> when I notice that something isn't working (eg., dot2tex, lie, coxeter3, >> gap_packages, fricas, bliss, macaulay2 ...) >> >> >> On Sat, Oct 11, 2025 at 6:12 PM Volker Braun <[email protected]> wrote: >> >> Does it actually hang there? the "meson setup" step takes quite a long >> time but eventually completes for me >> >> >> More than 3 minutes? If so, it would be nice if there could be some >> progress output. >> >> I'll report, >> >> Martin >> > -- You received this message because you are subscribed to the Google Groups "sage-devel" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion visit https://groups.google.com/d/msgid/sage-devel/274daa90-5064-4026-95e5-2994a2c4d15dn%40googlegroups.com.
