Not sure about version (4) I haven't upgraded yet. But on version (3) under
CHECKS you select SNMP. On this page you then select ALARM when **********
is <= or > than ********. the first number is the MIB (i think that the
correct name) that you want to check. Then second numbers is what the MIB
is set to. And then you can select if your looking to get an alarm if the
MIB is < or > or = to the second number... I hope this is of some help.
It's been a while. I had SALIVE checking an APC UPS and alarming when the
UPS lost ac power...
At 09:46 AM 6/10/03 -0400, you wrote:
>Hello,
>I am trying to figure out how to do this.
>>From looking through SA 4 it appears that I should be able to receive
>and do something with snmp traps, but I'm not seeing anyway to do that.
>I'm seeing how to send a trap from SA.. but how do I setup receiving of
>traps?
>--
>Matt <[EMAIL PROTECTED]>
>
>To unsubscribe from a list, send a mail message to [EMAIL PROTECTED]
>With the following in the body of the message:
> unsubscribe SAlive
>
>
Regards,
Gene [EMAIL PROTECTED]
[EMAIL PROTECTED]
http://www.eclipse.net/~njkat
To unsubscribe from a list, send a mail message to [EMAIL PROTECTED]
With the following in the body of the message:
unsubscribe SAlive
