SA has this built in - sort of. You can have it send a keepalive message every x minutes. If you set that to every 1440 minutes that will be 24 hours.
This doesn't completely solve your problem since you would get messages every 24 hours after you start SA. I haven't tried it but you could have it send messages every 60 minutes to an email address. That address could then use to On-Call schedule to only receive messages between 5:30 and 6:30. It should work. I can test this a little when I get to the office tomorrow. Dirk - the docs don't say what address the keepalives are sent to. I'm guessing the default smtp is correct. Can you confirm this? -Kevin > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Ferrell, Jim > Sent: Wednesday, September 03, 2003 3:31 PM > To: [EMAIL PROTECTED] > Subject: [SA-list] SA - Health Check > > > I have been assigned a mission to perform pre-production > health checks. > > One item on my list is to have Servers Alive send a page > everyday at 6:00 AM to confirm that Servers Alive is working. > > Does anyone have creative solution? > > Jim Ferrell > EDS - Allison Transmission > Mail Stop M-12A > 4700 W 10th St > Indianapolis, IN 46222 > > * phone: +01-317-242-0034 (8-252) > * mailto:[EMAIL PROTECTED] > Cell phone: 317-716-4541 > > To unsubscribe from a list, send a mail message to > [EMAIL PROTECTED] With the following in the body of the message: > unsubscribe SAlive > To unsubscribe from a list, send a mail message to [EMAIL PROTECTED] With the following in the body of the message: unsubscribe SAlive
