Looks like the error is due to the high encryption.
IF the high enctryption is enabled without the hostfile being loaded, SA
will convert the password that are within the setup to high encryption but
those in the hostfile are not and this causes the error 13 when using the
hostfile.
The simple solution is:
* disable high encryption (this can only be done via the registry!)
(HKEY_LOCAL_MACHINE\SOFTWARE\DBU Consulting\Servers
Alive\StartUp\UseHighEncryption with a value of 0)
BUT you will have to retype all the password that are in the setup.
Now the question is did you install the 1599/1600 OVER an existing
installation? If so did you enable the high encryption manualy (without
loading the file?)
Or did you do a fresh install (on a system without a previous SA installed)
and used the "old" hostfile?
Dirk.
Woodstone's office are closed from April 22nd until April 26th 2004.
Don't forget to vote for Servers Alive in the annual Sunbelt Target Awards
http://www.sunbelt-software.com/targetawards/
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]
Behalf Of David Wheeler
Sent: Saturday, April 24, 2004 12:06 AM
To: [EMAIL PROTECTED]
Subject: RE: [SA-list] "Run-time error '13': Type mismatch"
I had some problems with my SA hanging so I upgraded to 4.1.1600.
I then encountered similar problems with HTTPS and Oracle Checks using
4.1.1600 with Run time 13 Errors.
I then removed the microsoft patches. and downgraded to 1591. I then
retyped the passwords for HTTPS. Both HTTPS and Oracle then seemed to
be ok.
It seems to be either the beta OR the beta SA+ms patches.
Note: Condensed for brevity.
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On
Behalf Of [EMAIL PROTECTED]
Sent: Friday, April 23, 2004 2:29 PM
To: [EMAIL PROTECTED]
Subject: [SA-list] "Run-time error '13': Type mismatch"
When I was running Servers Alive 4.1.1591, I had several checks set up
to check perfmon logical disk counters for free megabytes, but I
constantly battled "element not found" errors. So I turned these checks
off. Recently, I read on this list that the newest beta version (1599 at
the
time) resolved this "element not found" issue by checking disk space in
a different way.
However, when I upgraded to Servers Alive 4.1.1599, all of my perfmon
checks began to fail, and any attempts to edit a perfmon check results
in a "Run-time error '13': Type mismatch" message, after which Servers
Alive crashes.
I upgraded to beta 1600 today yet still see the same behavior.
Any advice? I'd rather not recreate all of the perfmon checks if I
don't have to.
Thanks!
--
Jim Vaughan
FAX: 402-399-3533
Information Services / Telecommunications & Networking
Central States Health & Life Co. of Omaha - http://www.cso.com
---
[This E-mail scanned for viruses by Declude Virus]
To unsubscribe from a list, send a mail message to [EMAIL PROTECTED]
With the following in the body of the message:
unsubscribe SAlive
The information contained in this email message may contain confidential or
legally privileged information and is intended solely for the use of the
named recipient(s). No confidentiality or privilege is waived or lost by
any transmission error. If the reader of this message is not the intended
recipient, please immediately delete the e-mail and all copies of it from
your system, destroy any hard copies of it and notify the sender either by
telephone or return e-mail. Any direct or indirect use, disclosure,
distribution, printing, or copying of any part of this message is
prohibited. Any views expressed in this message are those of the individual
sender, except where the message states otherwise and the sender is
authorized to state them to be the views of XOMA.
---
[This E-mail scanned for viruses by Declude Virus]
To unsubscribe from a list, send a mail message to [EMAIL PROTECTED]
With the following in the body of the message:
unsubscribe SAlive
---
[This E-mail scanned for viruses by Declude Virus]
To unsubscribe from a list, send a mail message to [EMAIL PROTECTED]
With the following in the body of the message:
unsubscribe SAlive
