How would I proceed to investigate the possibility of a custom change?
Is it that the MIB is built into the application and you would need to edit it or...
| "Dirk Bulinckx"
<[EMAIL PROTECTED]>
Sent by: [EMAIL PROTECTED] 06/20/2005 01:12 PM
|
|
With some changes to SA yes....but currently not planned....
(a custom change is always possible although)
Dirk.
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of [EMAIL PROTECTED]
Sent: Monday, June 20, 2005 7:08 PM
To: [email protected]
Subject: RE: [SA-list] SNMP trap sending
I was hoping for the ability to set them manually...per alert within Servers Alive.
For example, I figured out that to see the trap in my trap receiver that Servers Alive is forwarding, I need to look within enterprise 10984 at identifier "0". I would like to be able to send traps via identifier 0, 1, or 2, as defined by the "check" itself.
Does this sound like a possibility?
| "Dirk Bulinckx"
<[EMAIL PROTECTED]> Sent by: [EMAIL PROTECTED] 06/20/2005 12:05 PM
|
|
and those levels how are they determined?
Dirk.
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of [EMAIL PROTECTED]
Sent: Monday, June 20, 2005 6:02 PM
To: [email protected]
Subject: [SA-list] SNMP trap sending
When using a "SNMP trap" alert to forward the check results onto a trap receiver, is there a way to configure more than one type of trap/identifier? My goal is to be able to forward traps based on 2 or 3 different severity levels.
Thank you in advance,
Alisha Krecidlo
American Power Conversion
