I am on Solaris 8 with Samba 2.2.4. When I configure a printer it sets 'oplocks = No' in the printer share. When I run testparm it then gives me an error message;
Invalid combination of parameters for service insp0101. Level II oplocks can only be set if oplocks are also set. The dump shows that in the [global] section 'oplocks' and 'level2 oplocks' are both set to the default Yes. If I manually change 'oplocks = Yes' in the printer share, testparm runs clean. Why would using SWAT put this entry in a printer share? Should I be concerned?? - Graeme -- To unsubscribe from this list go to the following URL and read the instructions: http://lists.samba.org/mailman/listinfo/samba
