I just figured out that the error given below is not actually an error. It must be some sort of informational message. Anyway the command works fine even though I get the message below.
On Fri, Nov 22, 2002 at 11:00:02AM -0600, Benjamin Herbert wrote: > > > I started smbd nmbd then ran the command 'wbinfo -A DOMAIN+adm%passwd' > which gave this error: > > could not obtain winbind separator! > > As you can see the second error was fixed but I still get the winbind > separator error. Winbind crashed when I tried to start it after running > the command above. > > Any other ideas? > > Thanks for the reply. > > On Fri, Nov 22, 2002 at 11:08:22AM -0500, [EMAIL PROTECTED] wrote: > > "Collins, Kevin" wrote: > > > > > > 5) Before starting smbd, nmbd winbindd I run 'wbinfo -A admin%password > > > > -here is the error I get: > > > > > > I think this is your problem: I believe smbd, nmbd and winbindd all > > > need to be running for this work. Someone correct me if I'm wrong. > > > > Nope, this should be run before winbindd. Some wbinfo calls require > > winbindd to be running, but this sets the userid that winbindd will use to > > connect to the DC. > > > > I think the problem is that you need to have 'wbinfo -A > > DOMAIN+admin%password', that is, add in the domain and winbind separator on > > the wbinfo command. > > > > Jim McDonough > > Samba Team > > > > -- > > To unsubscribe from this list go to the following URL and read the > > instructions: http://lists.samba.org/mailman/listinfo/samba > -- > To unsubscribe from this list go to the following URL and read the > instructions: http://lists.samba.org/mailman/listinfo/samba -- To unsubscribe from this list go to the following URL and read the instructions: http://lists.samba.org/mailman/listinfo/samba
