Hi, It is Part of xp here not samba. xP sp3 is somewhat different with w2000. I managed to run some older Programs in give full acls on the client for the domain users and on the samba server. Greetings Daniel
----------------------------------------------- EDV Daniel Müller Leitung EDV Tropenklinik Paul-Lechler-Krankenhaus Paul-Lechler-Str. 24 72076 Tübingen Tel.: 07071/206-463, Fax: 07071/206-499 eMail: [email protected] Internet: www.tropenklinik.de ----------------------------------------------- -----Ursprüngliche Nachricht----- Von: [email protected] [mailto:[email protected]] Im Auftrag von Gaiseric Vandal Gesendet: Freitag, 22. Oktober 2010 05:11 An: [email protected] Betreff: Re: [Samba] Application will not run for domain user Two possible options: 1) It may not be a local vs domain user issue. It may be an administrator vs non administrator issus. Can you add the domain user to the local administrators group? 2) It may be the file permissions- samba doesn't always translate the unix acl's to windows properly. If you can run quicken with the data on the XP machines local hard drive than this is the case. What is the Samba PDC OS and File system? I found Solaris 10 ZFS was especially tricky. If you right click on a network directory or file, and check the permissions do you get an warning about permissions being incorrectly ordered? Can you check effective permissions to see if a "deny group" is overriding an "allow user?" -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Robert Moskowitz Sent: Thursday, October 21, 2010 10:48 PM To: [email protected] Subject: [Samba] Application will not run for domain user I have set up a Samba PDC using the Amahi.org distro, so there might be some things they still have a bit off... Anyway, I have a somewhat old program, Quicken 2000. On my old Win2K workstation on an old NT server, it ran just fine for domain users. The software is installed on the workstation, and the data is on the server. But on my new XP Pro workstation on my new Samba PDC, it only runs for a local user, and that user is a super user (I have not created a regular user on the system yet). It will not run for the domain user. I reinstalled the software while logged on as the domain user. I got prompted to supply a user with admin privs for the install, which I did. I still cannot run the program from the domain user. Where do I look to fix this? -- To unsubscribe from this list go to the following URL and read the instructions: https://lists.samba.org/mailman/options/samba -- To unsubscribe from this list go to the following URL and read the instructions: https://lists.samba.org/mailman/options/samba -- To unsubscribe from this list go to the following URL and read the instructions: https://lists.samba.org/mailman/options/samba
