Hello, I noticed the following issue:
when I add the default configuration for ldapsearches from the Howto
collection �10.4.4.6, example 10.2
ldap filter = (&(uid=%u)(objectclass=sambaSamAccount))
to smb.conf I cannot run
smbpasswd -a [username]
anymore. It works fine without the ldap filter statement.
I noticed that the ldap queries are different with ldap filter activated
( from the ldap logfile ):
Sep 18 14:02:33 fermat slapd[1952]: conn=107 op=29 SRCH base="ou=Riege
Software,dc=riege,dc=com" scope=2
filter="(&(&(uid=jaeger)(objectClass=sambaSamAccount))(obje
ctClass=sambaSamAccount))"
Is the default wrong or does the filter not work at all?
regards, Gunther
--
Gunther Schlegel Riege Software International GmbH
Manager System Administration Mollsfeld 10
40670 Meerbusch, Germany
Email: [EMAIL PROTECTED] Phone: +49-2159-9148-0
Fax: +49-2159-9148-11
---------------------------------------------------------------------
Disclaimer:
You may grab my GPG key from http://www.keyserver.net .
A nonproportional font is recommended for reading.
signature.asc
Description: This is a digitally signed message part
-- To unsubscribe from this list go to the following URL and read the instructions: http://lists.samba.org/mailman/listinfo/samba
