On Wed, 20 Jul 2005, Jeremy Allison wrote:
> On Tue, Jul 19, 2005 at 08:43:07AM -0400, William Jojo wrote: > > > > Looked through the smb.conf.5 from 3.0.20pre2 for additional info on the > > aio settings but didn't seem to find them. > > > > I'm setting this up on AIX 5.2 and just wondered what where recommended > > starting values...and non-zero values activate the AIO code paths? > > Add > > "aio read size = 1" > "aio write size = 1" > Thanks, Jeremy. What I was really getting at was the release notes refer you to the smb.conf.5 man page for more information, which isn't there. :-) Perhaps I'm a bit dense this morning, but why would you set a read or write *size* to 1? I'm assuming this represents the aio_nbytes member of the aiocb struct? Cheers, Bill > in the global or share section smb.conf to activate. > > Jeremy. > -- > To unsubscribe from this list go to the following URL and read the > instructions: https://lists.samba.org/mailman/listinfo/samba > -- To unsubscribe from this list go to the following URL and read the instructions: https://lists.samba.org/mailman/listinfo/samba
