I think the command should be: smbclient -L <machinename> -U....
Eric HInes
At 12/16/05 13:39, Donald Musser wrote:
Hi everyone,
I'm using the online HOWTO manual in the "Quick Start" reference to try and
get a basic domain controller going. So I set up smb.conf, and testparm
checked out okay, I've started nmbd and smbd, but when I try to to run
[EMAIL PROTECTED] samba]#smbclient -L <username> -U<username>%<password>
session setup failed: NT_STATUS_LOGON_FAILURE <-- I get this error
Any ideas about what's causing this? I can post any relevant info as needed.
-Myles
--
To unsubscribe from this list go to the following URL and read the
instructions: https://lists.samba.org/mailman/listinfo/samba
There is no nonsense so errant that it cannot be made the creed of the vast
majority by adequate governmental action.
--Bertrand Russell
--
To unsubscribe from this list go to the following URL and read the
instructions: https://lists.samba.org/mailman/listinfo/samba
