Hi Mounir, Sorry for the late response.
You're using an ancient PIXMA backend version: 1.0.25. Please check your installation again. You should see backend version 1.0.27. Hope this helps. Cheers, Rolf Am 04.07.2018 um 06:43 schrieb Mounir Errami: > Hello all. > I am a linux enthusiast however I am hitting an issue with a Canon > printer (MF216n). I compiled Sane (scanimage (sane-backends) > 1.0.27git; backend version 1.0.25). > scanimage sees and detect my printer/scanner. I user the printer via > USB, not network. > scanimage - L: > "device `pixma:04A927A9_014CAA2B8A64' is a CANON Canon i-SENSYS MF210 > Series multi-function peripheral" > > > scanimage -T however provides the following output: > ---- > scanimage: scanning image of size 640x1050 pixels at 24 bits/pixel > scanimage: acquiring RGB frame, 8 bits/sample > scanimage: reading one scanline, 1920 bytes... PASS > scanimage: reading one byte... PASS > scanimage: stepped read, 2 bytes... PASS > scanimage: stepped read, 4 bytes... PASS > scanimage: stepped read, 8 bytes... PASS > scanimage: stepped read, 16 bytes... PASS > scanimage: stepped read, 32 bytes... PASS > scanimage: stepped read, 64 bytes... PASS > scanimage: stepped read, 128 bytes... PASS > scanimage: stepped read, 256 bytes... PASS > scanimage: stepped read, 512 bytes... PASS > scanimage: stepped read, 1024 bytes... PASS > scanimage: stepped read, 2048 bytes... PASS > scanimage: stepped read, 2047 bytes... PASS > scanimage: stepped read, 1023 bytes... PASS > scanimage: stepped read, 511 bytes... PASS > scanimage: stepped read, 255 bytes... PASS > scanimage: stepped read, 127 bytes... PASS > scanimage: stepped read, 63 bytes... PASS > scanimage: stepped read, 31 bytes... PASS > scanimage: stepped read, 15 bytes... PASS > scanimage: stepped read, 7 bytes... PASS > scanimage: stepped read, 3 bytes... PASS > ----- > At that point the scanner just stops and the "data processing light" > blinks. After a few seconds the scanner displays "Canceled" > When using simplescan the picture scan is blank. > > I am not sure what happens. I understand my model is not "fully > tested/supported" so any steps you'd like me to try, let me know. > > Thanks again for this super tool. I got it to work with another canon > but I no longer use that printer... > > Cheers. > -- sane-devel mailing list: [email protected] https://alioth-lists.debian.net/cgi-bin/mailman/listinfo/sane-devel Unsubscribe: Send mail with subject "unsubscribe your_password" to [email protected]
