Greetings, last June I started a thread on this list with the subject 'Error mess- ages when starting "scanimage"'. This eventually turned into an off- list discussion with Louis Lagendijk about the network aspect of this problem. In the course of this discussion I sent Louis plenty of debug information which he -- at least in part -- classified as "fishy", but which up to now do not seem to have been resolved (I receive the "sane- utils" package from Rolf Bensch's PPA, so the software should be fairly recent).
But apart from these error messages "scanimage" eventually connected to the scanner because configuration file "pixma.conf" contained the lines: bjnp-timeout=100 bjnp://192.168.2.199/timeout=5000 bjnp-timeout=100 But from these three lines aparently only the IP address was noted while the timeouts were ignored. However, back last June the problem of ig- nored timeouts was laid aside and we totally focused on the network iss- ues. I could live with that because "scanimage" just went through six timeouts of 1000 milliseconds each before it finally started. However, since some recent change the default timeout has been increased from 1000 milliseconds to 10000 milliseconds, causing a delay of a solid minute before "scanimage" gets going. That's just too much now, and I'm frantically looking for a way to change the default timeout. Anybody knows where to look? Any pointers appreciated. Sincerely, Rainer -- sane-devel mailing list: [email protected] https://alioth-lists.debian.net/cgi-bin/mailman/listinfo/sane-devel Unsubscribe: Send mail with subject "unsubscribe your_password" to [email protected]
