On Sat, 24 Nov 2001 01:01:10 -0600 Steven Lembark <[email protected]> wrote:
> > Having just read it again myself, from the rpm, sane-backends-1.0.5-4 > > > > BusLogic BT958 > > To configure the BusLogic card, you may need > > to follow these instructions (contributed by > > Jeremy <[email protected]>): During boot, > > when your BusLogic adapter is being initial > > ized, press Ctrl-B to enter your BusLogic > > adapter setup. Choose the address which > > your BusLogic containing your scanner is > > located. Choose ``SCSI Device Configura > > tion''. Choose ``Scan SCSI Bus''. Choose > > whatever SCSI id that contains your scanner > > and then choose ``View/Modify SCSI configu > > ration''. Change ``Negotiation'' to > > ``async'' and change ``Disconnect'' to > > ``off''. Press Esc, save, and Esc again > > until you are asked to reboot. > > Double checked the BT-948 config, re-ran scanimage -L w/ > debugging turned on. Still no luck (see attached). The > sane-find-scanner quickly identifies the device as my > scanner; it's scanimage that keeps blowing up. You did try it also with disconnect set to default, instead to off? -- Marcel Pol [email protected] Linux 2.4.13-8mdksmp, up 6 days 7:23
