Hi, My Epson Perfection 1650 (internal name: GT 8200) works as expected. The problem is that I get the following messages when using sane-find-scanner, scanimage or any other frontend:
cat /var/log/messages: kernel: scanner.c: open_scanner(1): Unable to access minor data kernel: scanner.c: open_scanner(2): Unable to access minor data kernel: scanner.c: open_scanner(3): Unable to access minor data kernel: scanner.c: open_scanner(4): Unable to access minor data kernel: scanner.c: open_scanner(5): Unable to access minor data kernel: scanner.c: open_scanner(6): Unable to access minor data kernel: scanner.c: open_scanner(7): Unable to access minor data kernel: scanner.c: open_scanner(8): Unable to access minor data kernel: scanner.c: open_scanner(9): Unable to access minor data kernel: scanner.c: open_scanner(10): Unable to access minor data kernel: scanner.c: open_scanner(11): Unable to access minor data kernel: scanner.c: open_scanner(12): Unable to access minor data kernel: scanner.c: open_scanner(13): Unable to access minor data kernel: scanner.c: open_scanner(14): Unable to access minor data kernel: scanner.c: open_scanner(15): Unable to access minor data ... The scanner is found as minor 0: open_scanner(0) is ok. With version 1.0.5 i did't have these messages. Other information: - Red Hat 7.2 (all updates installed) - Kernel 2.4.19 (build using RH config) - Sane-backends-1.0.8 (build from src.rpm) (before installing this version, v1.0.5 was removed) - Also tried Sane-backends-1.0.7 from RH7.3, but with the same odd results. - from /var/log/messages: kernel: usb.c: registered new driver usbdevfs kernel: usb.c: registered new driver hub kernel: usb-uhci.c: $Revision: 1.275 $ time 00:25:09 Sep 15 2002 kernel: usb-uhci.c: High bandwidth mode enabled kernel: PCI: Found IRQ 5 for device 00:04.2 kernel: PCI: Sharing IRQ 5 with 00:0d.0 kernel: usb-uhci.c: USB UHCI at I/O 0xd400, IRQ 5 kernel: usb-uhci.c: Detected 2 ports kernel: usb.c: new USB bus registered, assigned bus number 1 kernel: hub.c: USB hub found kernel: hub.c: 2 ports detected kernel: usb-uhci.c: v1.275:USB Universal Host Controller Interface driver kernel: hub.c: USB new device connect on bus1/1, assigned device number 2 kernel: usb.c: USB device 2 (vend/prod 0x4b8/0x110) is not claimed by any active driver. kernel: usb.c: registered new driver usbscanner kernel: scanner.c: 0.4.6:USB Scanner Driver - from /etc/modules.conf: alias usb-controller usb-uhci -from /etc/sane.d/epson.conf: usb /dev/usbscanner0 (crw-rw-rw) - /etc/dll.conf epson Can someone tell me what is wrong or what i'm doing wrong? Thanks, Martin Kho
