Good day. Awhile back with the help of people on this list I got Sane and my scanner playing nicely together!
Then I stoped needing to scan stuff for a bit and now when I go to scan with Xsane it starts up just fine, looks like it's all going to work but when you click on "preview" it says "Failed to start scanner: Operation not supported" and if you try it again it says "Failed to start scanner: Device is busy" Kooka just fails to do anything when you hit preview and xscanimage gives the same error that xsane does. Any ideas? I know the scanner is good (I just used it in winders) I looked at the verbose output of xsane and cannon after exporting the debug level to 128 but there does not seem to be any error messages contained within. the only thing odd is this: [canon] << sane_get_parameters [canon] do_focus: sending GET FILM STATUS [canon] >> get film status [canon] >> sense_handler [canon] canon_sense_handler(3, 0x40508060, 0x80a85b0) [canon] sense buffer: f0 00 45 00 00 00 00 06 00 00 00 00 20 00 00 00 [canon] sense buffer: Invalid Command Operation Code [canon] << sense_handler [canon] << get film status [canon] do_focus: GET FILM STATUS failed [canon] attach: sending GET SCAN MODE for scan control conditions [canon] get scan mode: cmd[4]='0x14' Segmentation fault which is what I get when I type just "scanimage" This is the last block of output from the run of "xsane" [canon] >> sane_get_parameters [canon] sane_get_parameters: width='5102', xres='300', mud='600' [canon] sane_get_parameters: length='7014', yres='300', mud='600' [canon] sane_get_parameters: pixels_per_line='2551', lines='3507' [canon] sane_get_parameters: xres='77', yres='77', pixels_per_line='2551', bytes_per_line='7653', lines='3507' [canon] << sane_get_parameters [canon] >> sane_get_parameters [canon] sane_get_parameters: width='5102', xres='300', mud='600' [canon] sane_get_parameters: length='7014', yres='300', mud='600' [canon] sane_get_parameters: pixels_per_line='2551', lines='3507' [canon] sane_get_parameters: xres='77', yres='77', pixels_per_line='2551', bytes_per_line='7653', lines='3507' [canon] << sane_get_parameters Btw i'm using Debians sane packages: ii libsane 1.0.9-3 API library for scanners ii libsane-dev 1.0.9-3 API development library for scanners ii sane 1.0.9-3 Scanner graphical frontends ii sane-utils 1.0.9-3 API library for scanners -- utilities ii xsane 0.89-3 A gtk-based X11 frontend for SANE ii xsane-common 0.89-3 A gtk based X11 frontend for SANE Any ideas? -- Kevin J Poorman <[email protected]>
