On Tue, 28 Sep 2004 22:37:27 +0900 "mitsuru okaniwa" <[email protected]> wrote:
> Dear Thomas, > Thank you very much for your useful try! Dear Mitsuru, Thank you for helping me trying it ;-) ... > In these test case, I recommend you to edit Makefile(it is in directory of > /sane-backends-1.0.XX/backend/) after did "configure", as follows; ... > > I could compile the sane different version test (case1. and case2.) by the > above way on my Linux. > If you will have the compile error again, would you send me the error > massage of your compiler? > With your help to edit the Makefiles I also could compile these two testcases. Case 1 (copy canon.c, canon.h, canon-scsi.c, canon-sane.c and sanei_backend.h rom sane-backend-1.0.14 to sane-backend-1.0.11) But the scan error still exist Case 1 (copy canon.c, canon.h, canon-scsi.c, canon-sane.c and sanei_backend.h rom sane-backend-1.0.11 to sane-backend-1.0.14) This test gave me success! Scanning works fine! Thank you > > > The next test is.... > > > 3. copying only "sanei_scsi.c" file from sane-backend-1.0.11 into the > > > backend-1.0.14 and tried to compile the backend-1.0.14, install and test > > > Of course, canon files used are newest in sane-backend-1.0.14. > > > > > > "sanei_scsi.c" file is in directory of /sane-backends-1.0.XX/sanei/. > > > "sanei_scsi.c" was added some change around "sanei_scsi_req" between > > > sane1.0.11 and sane1.0.13. > > > > > Compiling was succesfully, but whan I try to scan, same behavior as in > sane-backends above 1.0.11 > > I mean, no success :-( > > Would you do "make clean" and "make" and "make install" again? > Tried it again, Still no success Thank you for not giving up! Any Ideas howto proceed? Best regards Thomas Loescher
