Hi everybody, I replaced the firmware 1.14 with the 1.16 I received (thanks Simon and Ken), but I have no change in the behaviour of my scanner. When I address the transparency unit, it runs into a loop. The debug ends repeating the attached block below over and over.
Any Ideas, any advice? thanks, Reinald [snapscan] atomic_usb_cmd(0,0x81dd3b8,66,0x0,0x0 (0)) [snapscan] usb_cmd(0,0x81dd3b8,66,0x0,0x0 (0)) [snapscan] usb_cmd: cmdlen=10, datalen=56 [snapscan] usb_write: writing: 0x24 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x38 0x00 [snapscan] Written 10 bytes [snapscan] usb_read: reading: 0xf8 0x00 0x00 0x00 0x00 0x00 0x00 0x00 [snapscan] Read 8 bytes [snapscan] usb_write: writing: 0x00 0x00 0x00 0x00 0x00 0x00 0x00 0x30 0x00 0x00 ... [snapscan] Written 56 bytes [snapscan] usb_read: reading: 0xfb 0x02 0x00 0x00 0x00 0x00 0x00 0x00 [snapscan] Read 8 bytes [snapscan] usb_request_sense [snapscan] usb_cmd(0,0xbfffcb00,6,0xbfffcae0,0xbfffcad4 (20)) [snapscan] usb_cmd: cmdlen=6, datalen=0 [snapscan] usb_write: writing: 0x03 0x00 0x00 0x00 0x14 0x00 [snapscan] Written 6 bytes [snapscan] usb_read: reading: 0xf9 0x00 0x00 0x00 0x00 0x00 0x00 0x00 [snapscan] Read 8 bytes [snapscan] usb_read: reading: 0xf0 0x00 0x02 0x00 0x00 0x00 0x00 0x0b 0x00 0x00 ... [snapscan] Read 20 bytes [snapscan] usb_read: reading: 0xfb 0x00 0x00 0x00 0x00 0x00 0x00 0x00 [snapscan] Read 8 bytes [snapscan] sense_handler(0, 0xbfffcae0, 0x8163f68) [snapscan] sense_handler: sense key: 0x02, asc: 0x04, ascq: 0x01, i1: 0x04, i2: 0x00 [snapscan] sense_handler: Not ready. [snapscan] sense_handler: Logical unit is in process of becoming ready. (4 seconds) [snapscan] sense_handler: Not ready. Am Dienstag, 16. August 2005 05:42 schrieb Ken Ramey: > Great news!! Using Simon's firmware file results in a good scan with > the transparency unit without colored bands! > > Thank you, Simon!! > > ken
