The Lexmark X3300 is unsupported by SANE. Its not even listed in the supported devices <http://www.sane-project.org/sane-mfgs.html> web page.
You could write your own driver, or make a request on this list that someone write one. I wouldn't hold my breath trying to get someone to write one. Its very difficult for the writer unless he has the exact same model for testing. Also, Lexmark is very close mouthed about their scanner technology, so the writer needs to do a lot of scans on a Windows machine using the Lexmark Windows driver and log the usb transfers and reverse engineer the backend from the log files. regards, Fred Odendaal Terrence van Ettinger wrote: > I'm trying to use scanimage with my Lexmark 3300, and >sane-find-scanner shows it, but when I try to do scanimage, it can't >find the scanner. What do I need to do about this? > >Thanks, >Terrence > > > > -------------- next part -------------- An HTML attachment was scrubbed... URL: http://lists.alioth.debian.org/pipermail/sane-devel/attachments/20051114/6534c3aa/attachment.html From [email protected] Tue Nov 15 07:48:05 2005 From: [email protected] (Levente =?ISO-8859-1?Q?Nov=E1k?=) Date: Tue Nov 15 08:03:07 2005 Subject: [sane-devel] Re: Re: Re: epson 3490 - transparency unit problem In-Reply-To: <[email protected]> References: <[email protected]> <[email protected]> <[email protected]> <[email protected]> <[email protected]> <[email protected]> <[email protected]> <[email protected]> <[email protected]> <[email protected]> <[email protected]> Message-ID: <[email protected]> On Mon, 2005-11-14 at 19:08 +0100, patrick deflandre wrote: > I have try the 2 methods, but I always have a green line across my scan. > This line is few pixel wide. > I can send you an example if you like. Two vague ideas (if the green line is vertical): - defective sensors (maybe a quality calibration would help a bit) - dirt on the calibration stripe or windows. Even a small dark spot on the area where shading correction is done could have a big impact, as it gets applied over and over for the whole scan height. Especially because you mentioned that the higher the resolution the wider the line. I would suspect a physical cause then. Levente
