Hi,
the driver support for your device is not yet complete. For some strange
reason the i/o ends very early during the TEST_UNIT_READY command.
Some trial'n error would be needed to find out what your scanner does
respond to and where are issues.
Do you have some C knowledge to comment some calls out and modify a value
here and there or do you need to send a patch for any of those test?
Yours,
On Monday 12 December 2005 19:37, Morten Hulden wrote:
> Hi,
>
> tested latest sane-backend (sane-backends-2005-12-10.tar.gz) on Minolta
> Dimage
> Scan Dual I (SCSI) film scanner but was unable to get an image.
>
> The scanner is connected to a AHA154x card on Linux FC4. A UMAX S-6E flatbed
> scanner on the same bus works just fine.
>
> dmesg:
> scsi0 : Adaptec 1542
> Vendor: Minolta Model: #2882 Rev: 1.10
> Type: Scanner ANSI SCSI revision: 02
--
Ren? Rebe - Rubensstr. 64 - 12157 Berlin (Europe / Germany)
http://www.exactcode.de | http://www.t2-project.org
+49 (0)30 255 897 45
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: application/pgp-signature
Size: 189 bytes
Desc: not available
Url :
http://lists.alioth.debian.org/pipermail/sane-devel/attachments/20051213/6b185f4e/attachment.pgp
From [email protected] Tue Dec 13 11:41:21 2005
From: [email protected] (amth)
Date: Tue Dec 13 11:57:21 2005
Subject: Vs: [sane-devel] Progress on CanoScan 3200F
Message-ID: <[email protected]>
>----Alkuper?inen viesti----
>L?hett?j?: [email protected]
>P?iv?m??r?: 2005/12/13 8:39
>Vastaanottaja: <[email protected].
debian.org>
>Aihe: [sane-devel] Progress on CanoScan 3200F
>
>Hello,
>
>I have no such technical information that I could
>say if CanoScan
3000F is sufficiently close to
>3200F so that the same driver would
work. In fact
>I doubt it. But it is possible to check the case,
>if
you could take an USB log of booting the scanner
>and scanning a small
image, I could take a look at
>it and see if the engine in 3000F is
same or similar.
I have some scan/init logs captured from the CanoScan
3000F, but unfortunately can't seem to find enought time to dev the
backend for it, I could email them directly to you if you would like to
have a look at them... ?
And in case you happen to be stationary at
hel.fi, I could even loan such unit for you (with RF shielding soldered
off). :-)
--
amth
