Rene Rebe wrote: > Hi, > > On Sunday 23 April 2006 23:28, Erik P. Olsen wrote: > >>> On Sunday 23 April 2006 13:02, Erik P. Olsen wrote: >>>>> Aside the stripe the image is completely fine? Does it only happen when >>>>> you scan the whole page? E.g. is due to some plastic on the side and >>>>> the other software just allow scanning a smaller region? Or does it >>>>> happen for scans in the middle of the page as well? >>>> It does not happen with a smaller region. However, I can reduce the scan >>>> by so small an amount that the yellow stripe will still show up just >>>> smaller. But I can also see that the yellow stripe overlays the picture, >>>> so it is not some plastic on the side or similar, it is actually induced >>>> by the backend. >>>> >>>> BTW, there is also a tiny green stripe about 1/5 of the width of the >>>> yellow stripe. >>> Hm, maybe then something is or got wrong for the 7400 calibration. >> Anything I can do for the calibration? > > The calibration is done (for scanners requiring this) by the avision driver. > Most probably some regression (e.g. support for other calibration data > layout) was introduced since I know it noce works perfectly for the HP 7400. > > You can either try older versions and tell me which one work, read the > svn history like svn log http://svn.exactcode.de/sane-avision/trunk or > the code directory to find out where it goes wrong. I'll take a look in some > days when the important stuff from my desk is done.
Where can I find the older versions? -- Regards, Erik P. Olsen.