m. allan noah wrote: > On Fri, 25 Aug 2006, Matthew wrote: > >> m. allan noah wrote: >>>> scanimage: scanning image of size 5104x6600 pixels at 1 bits/pixel >>>> scanimage: acquiring gray frame >>>> [fujitsu] sane_read: start >>>> [fujitsu] read_from_scanner: start >>>> [fujitsu] read_from_scanner: si:0 to:4210800 rx:0 re:4210800 bu:65536 >>>> pa:65076 >>>> [fujitsu] do_usb_cmd: start >>>> [fujitsu] in: return error 'End of file reached' >>>> [fujitsu] read_from_scanner: got EOF, changing to GOOD >>> >>> hmm. i bet that is the culprit. i bet we should catch that eof, and run >>> status anyway. instead of continuing. normally the 5120 is in blocking >>> mode, and does not do this. even if we get the io error later to work, >>> this will corrupt the image anyway, so it has to be fixed. >>> >>> did you have the scanner connected to windows, then connect it to linux, >>> without power cycling the scanner? if the windows driver sets up the >>> scanner for some kind of non-blocking or buffering mode, this would >>> happen. >>> >>> if you power cycle the scanner while its connected to linux, does this >>> happen still? >>> >>> allan >>> >> >> Ok, time for me to sound extremely stupid, but how do I power cycle the >> scanner. If your talking about simply turning it off and on then yes I >> have done that and it still errors out. >> > > better pull the power cord and wait 30 seconds or so before > reconnecting, just to make sure. > > allan >
Didn't work. Log file said the same thing. I've been looking for a hard reset to factory default, but thus far I've found nothing.
