Konstantin Svist <fry.kun at gmail.com> writes: > Hi there, > > I was wondering if support for Epson CX7400 could be added.
This model will be supported by the upcoming 2.10.0 release of iscan. > I saw a bunch of close model numbers are supported, so it's probably > not too hard (I just don't know how to do it) That does not always mean much. > I tried following instructions on > http://linuxprinting.org/show_printer.cgi?recnum=Epson-Stylus_DX7400 > (specified the deviceid in /etc/sane.d/epson.conf and added a udev > rule - though, I used a copy of similar entry from > /etc/udev/rules.d/60-libsane.rules file instead of the line quoted on > the page above) > > So far, "scanimage -L" identifies the device properly and xsane sees > it - but cannot scan anything; I get some kind of I/O error. The epson backend seems to have trouble with a number of all-in-one devices, AFAIK. I have taken a look at it in the past, comparing to the epkowa backend (part of iscan), but couldn't quite put my finger on it. FWIW, you can use the epkowa backend just fine with scanimage and xsane. Hope this helps, -- Olaf Meeuwissen FLOSS Engineer -- EPSON AVASYS Corporation FSF Associate Member #1962 sign up at http://member.fsf.org/ GnuPG key: 6BE37D90/AB6B 0D1F 99E7 1BF5 EB97 976A 16C7 F27D 6BE3 7D90 Penguin's lib! -- I hack, therefore I am -- LPIC-2
