Hello Stef I have been on a summer holiday so I could not do the test earlier. I downloaded the new version of sane-backends-genesys from your web page. I configured it with |./configure --enable-libusb and then ran make| I then attached and switched on the scanner, changed to the backend directory and ran ./run-genesys Absolutely nothing happened. I commented out the 600dpi line in run-genesys and re-ran it. Again, nothing happened. This is a completely new installation of sane-backends-genesys so do I need to uncomment an hp2400c line anywhere?
Regards, Rob stef wrote: > Hello, > > the genesys backend as been updated. Thanks to an hardware donation of > Jack > McGill, there is now support for the sheet-fed Visioneer Strobe XP200. It can > scan at 75, 100, 200, 300 and 600 dpi in color or gray and at 8 or 16 bits. > Scans are uncalibrated, ie there is no shading nor gain calibration. The next > step is to add calibration which use an external sheet with printed patterns. > There is also button support for the Medion 534, the HP 2300 and Strobe > XP200 > The 'motor bug' at 100 dpi for gray scans affecting the MD5345 is still > unresolved. > The backend should also now be able to scan at 50 or 300 dpi with an > HP2400. > > Regards, > Stef > >
