> The fujitsu sane backend does not support software changes to that > setting, because it was effectively read-only in older scanners. I > think the newer machines might support software control of that value. > I will try to find some time to look at that this weekend.
Thank you Allan! Regards, Simon > > allan > > On Fri, Feb 28, 2014 at 6:35 AM, Simon Matter <simon.matter at invoca.ch> > wrote: >> Hi, >> >> I'm using sane-backends-1.0.24 to access a new Fujitsu fi-7160. >> >> The manpage shows this in the Sensor section: >> >> --function <int> [0] [hardware] >> Function character on screen >> >> My question is, is there a way to set a sensor value by software, not >> using the buttons on the device? >> >> The main question is because Fujitsu has changed the default function to >> 0 >> in the newest device series while it was 1 in older devices like the >> fi-6130. >> >> Regards, >> Simon >> >> >> -- >> sane-devel mailing list: sane-devel at lists.alioth.debian.org >> http://lists.alioth.debian.org/cgi-bin/mailman/listinfo/sane-devel >> Unsubscribe: Send mail with subject "unsubscribe your_password" >> to sane-devel-request at lists.alioth.debian.org > > > > -- > "The truth is an offense, but not a sin" >
