On 14/01/2016 08:51, Jan Beranek wrote:
Hello,
so I tried to be very patient, the scanner was running over night, like 8 hours.
So far nothing, scanner did some sound only in the beginning, later
nothing. I already had to disconnect the scanner, I will try it again
over this night - but honestly, how long this calibration take? It is
really more than 8 hours?
(I've not taken debug.log as this would be too huge)
Kind Regards
Jan.
Hello,
it is a matter of minutes not hours. Something isn't going right.
Could you send the debug log a small gray scan with the following commands:
export SANE_DEBUG_GENESYS=255
export SANE_DEBUG_GENESYS_LOW=255
export SANE_DEBUG_GENESYS_GL847=255
export SANE_DEBUG_GENESYS_GL124=255
scanimage -d genesys --clear-calibration --width 50.0 --height 50.0
--mode Gray --resolution 2400 2>scan.log >scan.pnm
Regards,
Stef
--
sane-devel mailing list: [email protected]
http://lists.alioth.debian.org/cgi-bin/mailman/listinfo/sane-devel
Unsubscribe: Send mail with subject "unsubscribe your_password"
to [email protected]
