Hi there, I just got my new TS8050 and tried to configure SANE to scan from the TS8050 over the network (the same way worked for my old PIXMA MX925).The Scanner is listed as "Testers needed" on the SANE website, so here's my experience report:
The scanner has a static IP set to 192.168.1.3, my sane configuration contains the following entry: bjnp://192.168.1.3 When I run `scanimage -L` I get the following error message: [bjnp] udp_command: ERROR - no data received (timeout = 1000) > [bjnp] bjnp_init_device_structure: Cannot read mac address, skipping this > scanner > [bjnp] udp_command: ERROR - no data received (timeout = 1000) > [bjnp] add_scanner: ERROR - Cannot read scanner make & model: bjnp:// > 192.168.1.3:8612/timeout=1000 > device `v4l:/dev/video0' is a Noname Integrated Camera virtual device When I try and scan the device with nmap I get the following report: ~ sudo nmap -sU 192.168.1.3/32 > Starting Nmap 7.50 ( https://nmap.org ) at 2017-06-15 11:25 CEST > Nmap scan report for 192.168.1.3 > Host is up (0.036s latency). > Not shown: 993 closed ports > PORT STATE SERVICE > 68/udp open|filtered dhcpc > 161/udp open snmp > 500/udp open|filtered isakmp > 1900/udp open|filtered upnp > 1901/udp open|filtered fjicl-tep-a > 5353/udp open zeroconf > 5355/udp open|filtered llmnr > MAC Address: 84:BA:3B:83:58:44 (Canon) > Nmap done: 1 IP address (1 host up) scanned in 3.48 seconds Looks to me like the bjnp protocol is not supported by this model? Is there any other test I can run to help? Best regards, Johannes
-- sane-devel mailing list: [email protected] http://lists.alioth.debian.org/cgi-bin/mailman/listinfo/sane-devel Unsubscribe: Send mail with subject "unsubscribe your_password" to [email protected]
