Hi, when calling a show command (e.g. show state or show io) at a dbmcli (v7.3.0.18 on a HP-UX 11.0 box) prompt I get an error message at the end of the reply. See the two examples below:
dbmcli on s_herm1>show io OK SERVERDB: S_HERM1 Devspace No. Read(s) Write(s) Total [...] total I/O 30 6 36 aCC runtime: ERROR: _main() not called. dbmcli on s_herm1>show state OK SERVERDB: S_HERM1 The database state is WARM aCC runtime: ERROR: _main() not called. I get this error message when calling nearly every show command (exception: show all, show t_cnt, show t_reg, show t_stat). What is the meaning of t his? Is there any effect on the reliability of the database system? kind regards Frank Schimmelpfennig PHILIPS Semiconductors Hamburg ATO-Hamburg IT&DataSupport Tel.: +49 40 5613 -1835, Fax: -3020 _______________________________________________ sapdb.general mailing list [EMAIL PROTECTED] http://listserv.sap.com/mailman/listinfo/sapdb.general
