I think you took the wrong path through the GUI. You have to choose "installation with recovery" and not only "installation".
With a complete installation you created a new database instance which has an own identifier (db_ident). This identifier is written to the log and to the data volumes. If you recover the data backup from your old instance the data volumes have the old identifier but this does not match the new identifier of the log volume. (This is shown in the knldiag.) regards Uwe > -----Original Message----- > From: Arne Gehlhaar [mailto:[EMAIL PROTECTED]] > Sent: Donnerstag, 16. Januar 2003 14:23 > To: [EMAIL PROTECTED] > Subject: Recovery fails with DBMGUI > > > Hi, > > I am experiencing problems when trying to migrate a database from one > computer to another. I used the DBMGUI to do a complete data > backup with > checkpoint of the source db. I can recover the destination db > from the > backup medium, but when I try to restart it I get the following error: > Error code -24988 sql error [db_warm -f]; -8003,Message not available > > In the knldiag it says: > 2003-01-16 13:24:38 4032 ERR 52444 LOG db_ident mismatch > > Using the DBMCLI (following the steps of the Backup and > Recovery manual) > the same medium can be restored and teh db set into warm mode without > problems. What's wrong? > > Arne > > By the way, there's a small misprint in he manual > (sichwiederheng.pdf) > on page 9 "db wam" should read "db_warm" > > -- > Institute of Shipping Economics and Logistics http://www.isl.org/ > Arne Gehlhaar mailto:[EMAIL PROTECTED] > Universitaetsallee GW1 Block A phone:+49.421.22096.49 > D-28359 Bremen, Germany fax:+49.421.22096.55 > > _______________________________________________ > sapdb.general mailing list > [EMAIL PROTECTED] > http://listserv.sap.com/mailman/listinfo/sapdb.general > _______________________________________________ sapdb.general mailing list [EMAIL PROTECTED] http://listserv.sap.com/mailman/listinfo/sapdb.general
