Ken Teh wrote:
cpuspeed was off. If I say 'shutdown -h now', the machines powers off after a clean shutdown. If I say 'shutdown -r now', it brings the machine down. The last steps are remounting md0 readonly and syncing the SATA drives. The last line it prints on the screen is 'Restarting system'. Then, it just sits there. I have to use the front-panel switch to turn it off, then power it back on. Which is a bummer if you have to reboot it remotely. Btw, the front-panel switch is one of these new types when you have to hold it down for several seconds before it actually powers the machine off.

I'm wondering if it's some hardware problem. It's my understanding that a restart is basically like a push button reset. The last thing the CPU does is pull the reset line (A20 or A21 ??) which causes the M/B to go through its boot-up. But, now with ACPI and these smart power supplies, I was wondering if somehow this is the cause of my problem.

Any other suggestions?

I suspect this is an ACPI or chipset support problem which has been fixed in a later kernel. I have a couple of computers with the same ASUS M2NPV-VM motherboard (BIOS version 0801) and halting and rebooting works fine under CentOS 5.0 but hangs under CentOS 4.3. However, under CentOS 4.3, if I add acpi=off to the kernel boot command line, reboot works but not halt.

Shannon


Ken


Dan Halbert wrote:
Ken Teh wrote:
I just installed SL4.4 on an Athlon 64 machine with a ASUS M2NPV-VM motherboard. Shutdown works. The machine powers off. But, restart freezes. Bad hardware or is it some new-fangled power on/off/reset standard the hardware folks are foisting on us?

Do you mean that a cold boot (from power off) works, but a warm reboot doesn't? Try turning off cpuspeed:
 # service cpuspeed off
and then try again (starting with a cold boot). We saw this with an Opteron board.

Dan



--
____________________________________________

Shannon V. Davidson <[EMAIL PROTECTED]>
Senior Software Engineer               Appro
636-633-0380 (office)     443-383-0331 (fax)
____________________________________________

Reply via email to